ATI Catalyst 9.9

dasrab said:

Squonks is now my god.

F8 on bootup to disable w7 from blocking unsigned drivers and it works.

what are you talking about? i didn't see him mentioning anything about pressing f8 and disabling anything

and with the ATI Tray tools how do i go about and getting what i need done? finding the under/overscan slider ?

breeZy said:

dasrab said:

Squonks is now my god.

F8 on bootup to disable w7 from blocking unsigned drivers and it works.

what are you talking about? i didn't see him mentioning anything about pressing f8 and disabling anything

and with the ATI Tray tools how do i go about and getting what i need done? finding the under/overscan slider ?

Have you downloaded and installed ATI Tray Tools ?

ps. God works in mysterious ways. jk

yes i did but i must overlooked it cause i can't seem to find the option to over/underscan slider. do you happen to know where to go?

breeZy said:

yes i did but i must overlooked it cause i can't seem to find the option to over/underscan slider. do you happen to know where to go?

I will check and get back to you.

With the 64bit version for Windows 7, is anyone able to get the display driver to install properly or is that because it's unsigned?

Just that this might be the reason I have black bars in my steam games top on the top and bottom of the screen.

QuackPot said:

With the 64bit version for Windows 7, is anyone able to get the display driver to install properly or is that because it's unsigned?

Just that this might be the reason I have black bars in my steam games top on the top and bottom of the screen.

Go 5 posts back. F8......., there is your solution.

.

@breezy, haven't had a chance to check for you.

Wife is watching movies on HTPC.

breeZy said:

yes i did but i must overlooked it cause i can't seem to find the option to over/underscan slider. do you happen to know where to go?

Actually my solution, for whatever reason, seemed to be the unsigned driver that came with it. After installing tray tools it couldn't run because of the driver, so I restarted and hit F8 while booting, which takes you to a safemode options screen with the bottom option being to disable windows from blocking unsigned drivers. After that I loaded up tray tools and looked around, but didn't see anything either-

Try loading up CCC again and checking the ---configure option that had just given us the welcome screen. After the driver was enabled, or tray toools was run, the catalyst underscan options were suddenly where they were supposed to be. Very strange.