Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: DVI no signal

13 Nov 2013   #1
bbdowns124

windows 7 64 bit Home Premium
 
 
DVI no signal

When playing Call of Duty Ghosts, anywhere from 5 to 30 minutes into the game my screen goes black, the comp freezes and either one of these 2 messages are displayed:

1 - DVI no signal
2 - ASUS out of range

Soemtimes I don't get a message and the game just closes and the comp freezes.

I have and EVGA GeForce GTX nvidia 660Ti graphics card,
ASUS VG248QE monitor,
Windows 7 64 bit home premium,
and a verizon fios fiber optic IPS.

I have to restart my comp after this happens and then all is well again. I performed temp. tests and it ran from 49'c to 77'c while playing the game. The only other program that this happens to me is Battlefield 4. Otherwise, I never have a problem. All cable connections are fine. I even tried using different cables, plus I also tried an HDMI cable and still had the same problem. I lowered the settings way below what my setup is capable of and it still doesn't help. Last video settings used - 800x600 res, @ 60hz. Any help is greatly appreciated.




My System SpecsSystem Spec
.
13 Nov 2013   #2
AddRAM

Windows 7 Professional x64 Service Pack 1
 
 

Re install the video drivers, and make sure you do a custom/clean install.

http://www.geforce.com/drivers

And do you have Geforce Experience installed ?

http://www.geforce.com/geforce-experience

And is your monitor set to it`s native resolution ? Why are you using 800 x 600 ?
My System SpecsSystem Spec
13 Nov 2013   #3
bbdowns124

windows 7 64 bit Home Premium
 
 

I uninstalled the drivers and reinstalled them already. I do have/use GeForce Experience.
The 800x600 was only temporary, thinking it might help solve the problem. I also receive "ASUS out of range" messages upon freeze up occasionally. I put the res setting back to native res which is 1920x1080
My System SpecsSystem Spec
.

13 Nov 2013   #4
JoshKaye

Windows 7 Ultimate 64 bit
 
 

what can happen is higher end games like this are running alot of shaders. this can overload the video card. i have a GTX 660 SuperClocked. So i see this happen to me sometimes.

if you dont have Precision X EVGA here it is >> EVGA | Software | EVGA Precision

Make sure if your running these games that you have voltage at 100% or even 110%
you can also set max FPS -- 120

if this doesn't fix you can mess around with over-under clocking your card.
- Warning - dont go over 50 your GPU offset or 130 on memory clock -

and if your card is getting up to 77'c that's pretty high, i would recommend turning your graphics card off of auto fan speed, and up to 70% or more. I usually never let my card get higher then 63'c.

lastly when playing games like ghosts or BF4, turn anti-aliasing off and the option thats called HBAD all this does is increase small settings like plants on the ground or small rocks etc.
My System SpecsSystem Spec
13 Nov 2013   #5
bbdowns124

windows 7 64 bit Home Premium
 
 

Thanks Josh! I'll do all these things and post the results...
My System SpecsSystem Spec
14 Nov 2013   #6
bbdowns124

windows 7 64 bit Home Premium
 
 

Did all those things Josh but still have the problem. I filed a support ticket with Activision and even they don't know why it's happening. Their answer, "we have a patch coming out (no date) and maybe that will help". REALLY?
My System SpecsSystem Spec
14 Nov 2013   #7
JoshKaye

Windows 7 Ultimate 64 bit
 
 

Assuming you have a gtx 660 ti your computer must be custom built, I would recommend going inside and looking at the PCI E. Port and making sure it's in the x16 port not x8 or x4. Also make sure you have the 6-pin power connector in fully. Also let me know how much RAM your running and how many hrz and your processor and how many ghz. Last problem I could think off the top of my head would be your power supply, let me know the wattage of that if your running one 660 ti I would recommend a psu of atleast 650 wt. if you can't get any of these just give me the serial #'s and we can figure out your configuration to see if these games can be stablized with your system at all.
My System SpecsSystem Spec
15 Nov 2013   #8
bbdowns124

windows 7 64 bit Home Premium
 
 

All the connectors are secure and inserted properly. I have 18gigs of ram with the CPU - 940 @2.93ghz.
Power supply is 800 watts. The Nvidia GeForce Experience has optimized this game but I lowered all the settings to see if that would help, and it hasn't. I also adjusted my GPU with EVGA Precision as suggested by another responder above.
My System SpecsSystem Spec
Reply

 DVI no signal




Thread Tools




Similar help and support threads
Thread Forum
No signal to TV
To start, I don't have any alternative hardware to use. What I have is what I have to work with. I have a EVGA GTX 460 graphics card. It is sending the signal to my Samsung 32" LED through Mini HMDI -> HDMI. The problem I am having is that it won't display a signal. I need to get into my BIOS and...
Graphic Cards
Tv No Signal
Ok i tried to hook up my hdmi cable from my computer to my lg hd tv, but i get no signal, i tried detecting the tv but nothing came up. I have a Nvidia geforce 8600 Gt And a Gigabyte: GA-MA785GM-US2H motherboard. Thanks!
Graphic Cards
WMC and TV Tuner - No Signal / Too Weak a Signal
I have owned several TV Tuners in the past and this is the first OS that has given me problems. I have a Hauppauge WinTV-HVR-1950 (USB 2.0hs) and cannot get a picture from my Cox Cable Service in Orange County, Southern CA. Installed the 64bit driver from Hauppauge. According to Device...
Media Center
How can i get a TV signal?
Hello Win7 forums! I recently bought a hauppaugeTV HVR-2210 TV tuner card w/ a remote. However, I didn't realise that I had no antenna socket in my room... which means I'm not getting any TV. I wondering, would anybody have any ideas of how I could tune in? (other than using the...
Media Center
how to get tv signal into my pc?
Hi, I have a LCD TV, and a PC, but i no tv tuner card install on my pc. My TV and HTPC are connect via 1.3a HDMI cable. And I've look in TV section in WMC, but it said its need tv tuner card So, how can i get TV's signal into my PC without buying that card, by using some software that can get...
Media Center
No TV Signal
I am currently have a hauppauge 950Q tuner hooked up to my windows 7 computer. I have been having a problem where after about watching tv for about 6 minutes in windows media center it says that i have no tv signal and the image stops. It then says something about low bit rate. I would really like...
Media Center


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 19:22.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App