msconfig boot option problem please help

Page 3 of 3 FirstFirst 123

  1. karlsnooks
    Posts : 10,200
    MS Windows 7 Ultimate SP1 64-bit
       New #21

    from Microsoft msdn documentation:

    /numproc=number

    This switch sets the number of processors that Windows will run at startup. With this switch, you can force a multiprocessor system to use only the quantity of processors (number) that you specify. This switch can help you troubleshoot performance problems and defective CPUs.
      My Computer
    Quote Quote

  3. karlsnooks
    Posts : 10,200
    MS Windows 7 Ultimate SP1 64-bit
       New #22

    and another solid microsoft link:
    Using System Configuration
      My Computer
    Quote Quote

 
Page 3 of 3 FirstFirst 123

  Related Discussions
Hello, I recently was messing with my old laptop and kinda installed windows 7. There was a lot of problem during installing so before that, I tried installing XP and there was a problem of some sort of read error so in the boot option there is still the option for XP Setup for booting. So I...
I previously used MSConfig and selected the Boot tab "Advanced Options" to change the number of cores allocated to Windows, now I cannot open the Advanced Options at all. The selection is not grayed out so it should be accessable. Basically nothing under the Boot tab can be modified, the other tabs...
Hello everyone, going to update the drivers for your video card, I wanted to get into Safe Mode to clean, but entering msconfig. the tab "Startup Options" not responding? That is all the other entering it I can tick all the various options, while in boot options going to check "Start in Safe Mode"...
Two boot options in MSCONFIG
in General Discussion

When I start my computer, the boot manager comes up with two options that are the same. Windows 7 64 bit. When I open msconfig under boot it has two options and I cant delete one of them. Thanks for any help in advance
Hi. I had W7 7057 & XP running Fine, Dual Boot was working fine On The Same Disk but different partition: c: / W7 7057 d: / XP To install the W7 RC 7100 i've formatted the c: partition and installed on it. No problems at all during installation. W7 RC is running Fine.
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 02:57.
Find Us