How to connect to ethernet device?


  1. borgqueenx
    Posts : 111
    Windows Seven
       New #1

    How to connect to ethernet device?


    I have a RIYA Pro laser controller device. wich connects to the ethernet to receive commands from windows seven.
    Well my question is, how do i make windows regonise it?
    In the settings app of the controller(wich is installed on seven) it asks for a IP, submasks ect. But i have noooo idea what i should fill in there. windows, and the settings app, doesnt find the controller while it is connected to PC.

    But on the controller itself a red light of the network is on.
      My Computer
    Quote Quote

  3. Britton30
    Posts : 24,479
    Windows 7 Ultimate X64 SP1
       New #2

    Type cmd in the start Search, enter. In the command prompt window type ipconfig that will give you those numbers.
      My Computer
    Quote Quote

  4. borgqueenx
    Posts : 111
    Windows Seven
    Thread Starter
       New #3

    didnt work out...
    by the way...cute avatar :)
      My Computer
    Quote Quote

  6. Britton30
    Posts : 24,479
    Windows 7 Ultimate X64 SP1
       New #4

    Thanks :)

    Try this site IP Address | IP Address Tracer | IP-Adress.com to get your ISP ip address and then maybe the ipconfig numbers may help. If not, type in ipconfig /all.
      My Computer
    Quote Quote

 

  Related Discussions
Hi all, i need your advise pls. I have a Samsung series 7 laptop with 2 usb3 ports and 2 usb 2.0 ports. On the device manager i can see the installed driver Intel usb 3.0 root hub and intel usb 3.0 extensive host controller. I also have purchased a Samsung 64GB sdxc card SDXC UHS...
For some reason, my computer has been only connecting to ethernet recently. And I don't know what's going on, except for the fact that I recently performed a factory reset on my computer, and for some reason it caused a few problems on my laptop, most of which were fixed eventually though. However,...
I have a device connected through ethernet. i need to use it through ethernet but have no idea how. In the files of the software of the device is a network.ini file wich shows a adress i can chance. but i have no idea what the adress is i need to set. i can also connect the device over USB and...
I recently reinstalled windows and on a new hard drive and now it says my ethernet controller needs to be update. Without it i cannot use the internet without connecting to wifi, how do i update it?
Connect to Mac via Ethernet?
in Network & Sharing

Is there a way to connect a PC running W7 to a Mac running Snow Leopard (10.6.2) via an Ethernet cable? I wasn't able to make it work under Vista, but I was hoping W7 would have some changes under the hood to make it possible. (I have the Workgroup set up and the computers connected but when I...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 06:46.
Find Us