Replacement PSU Question

Page 2 of 2 FirstFirst 12

  1. Posts : 78
    Win 7
       #11

    Which PSU did you end up with in the exchange, if it boots using the old one I can't see it being anything else...............
      My Computer


  2. Posts : 12,012
    Windows 7 Home Premium SP1, 64-bit
       #12

    Here are some troubleshooting steps recommended by member TVeblen:


    Strip it down and then add components back, one at a time, to try and isolate the offending component.

    The test (power off, power cord unplugged):
    • Disconnect everything externally connected except the mouse and keyboard (printers, USB devices). If you are not using a wired mouse and keyboard see if you can borrow one.
    • Disconnect the power and data cables from all the drives inside the computer (Hard drives, DVD/CD drives).
    • Remove all the cards installed in the PCI slots including the video card. (be careful handling them and place them on a non conductive surface while testing).
    • Remove all the RAM sticks (same rules as above).
    Now connect the power cord and turn the PC on.
    • The motherboard should start beeping. You should get a beep code that tells you there is no memory. This is good, it means the processor is functioning and the motherboard is good so far.
    • Now add one stick of memory in Slot A1 and power on. More beeping: "no video card" beep code. This is good.
    • Then add the video card and connect it to the monitor. You should get no beeping and you should see the BIOS screens, ending with the message that there is no boot device.
    If you get no video then switch the one memory stick installed for another one and test.

    Continue adding components one at a time.

    If at any point the PC fails the the last component added was the problem one.

    If you removed everything and there is only the Motherboard (with integrated video), processor, and power supply to contend with and it does not POST or show anything on the screen, then the problem is one of those three.

    If you have tested by using another power supply then you are down to two. CPUs rarely fail, so motherboard is the most likely guess.

    Try performing a CLRTC or Clear CMOS as a last ditch effort, and check the 3v battery. Both long shots, but what do you have to lose at this point.
      My Computer


  3. Posts : 184
    Windows 7 Home Premium 64bit
       #13

    The rated wattage means little or nothing. What does the nameplate say for the +12V for both of the PSU's?
      My Computer


  4. Posts : 33
    Windows 7 Pro x64
    Thread Starter
       #14

    After removing the video card and resetting the CMOS I was able to get it to boot up periodically, but still eventually had the same freeze that Ive been attributing to a PSU issue since all the other HW has passed the tests I've thrown at it (everything recommended here + a friends geeksquad automated diagnostic disc).

    The PSU I have (best as I can find on the interwebs) is Bestec ATX-250-12Z Rev. D7R Replacement Power Supply 250W HP Part Number 5188-2622

    The model that I've bought + returned 2x is Micro Center - Cooler Master Elite Power 460 Watt ATX Power Supply RS460-PSARJ3-US

    What i'm planning on doing is returning it for one the recommended supplies today after work
    http://www.microcenter.com/single_pr...uct_id=0348766
    or
    http://www.microcenter.com/single_pr...uct_id=0361422

    ...and if that doesnt work, i'm giving up and ordering this rig...

    System Build - PCPartPicker
      My Computer


  5. Posts : 846
    Windows 10 Pro
       #15

    Get rid of the video card and swap out with your old one and see what happens.
      My Computer


  6. Posts : 33
    Windows 7 Pro x64
    Thread Starter
       #16

    IggyAZ, the issues came a few weeks after I put in the new card, I ran tests on the card and it seems fine, no display issues, not artifacts on stress testing, it runs cool, etc...
      My Computer


  7. Posts : 5,795
    Windows 7 Ultimate x64 SP1
       #17

    Can I make a suggestion that will help you now and down the road? Get a case and a motherboard, and put all of your existing parts in there. Then you don't have to worry about compatibility, cooling, etc.
      My Computer


  8. Posts : 33
    Windows 7 Pro x64
    Thread Starter
       #18

    I returned the CoolerMaster PSU and picked up a Corsair CX500 and everything started up just fine... weird... hopefully that was the last of my problems... I'll see how this works out for the freezes.
      My Computer


  9. Posts : 78
    Win 7
       #19

    It's all about quality control.........or lack of...........:)
      My Computer


 
Page 2 of 2 FirstFirst 12

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 10:31.
Find Us