Audio device and Mouse keep disconnecting, and reconnecting

Page 1 of 2 12 LastLast

  1. Posts : 6
    Windows 7 (64 bit Home Premium)
       #1

    Audio device and Mouse keep disconnecting, and reconnecting


    Ever since i started using Windows 7, my mouse and my audio drivers seem to keep resetting. I have made sure all my drivers for all my Windows components are up to date.

    I was using the built-in RealTech audio that came with my Asus P8Z68V motherboard, and every few minutes I would see the little message pop up saying it detected that I just plugged an audio device, and about as often, my mouse would suddenly stop working, and then reconnect. both would be followed by that sound windows makes when it just detected a new device had been disconnected. So it's almost like Windows is resetting my IRQ or DMA or something, or it just drops the port, and opens it again.

    I can verify that I am not constantly unplugging my speaker jack and mouse, so its not me. :) I even went into the BIOS and disabled the on-board sound and installed a sound Blaster X-Fi card, and it made no difference.

    I tried connecting my Logitech MX518 mouse to another USB port, and it did not help. I am using a Logitech G19 keyboard, so I relocated my mouse to a USB port on the keyboard and it seems to do it a bit less often. <shrug>

    This problems happens all the time, no matter if I am playing a game, browsing the internet, etc... The sound will stop for about a half second, or the mouse will freeze, and then they reconnect as if nothing happened... except for the Windows default sound event for "device disconnect". They do not disconnect together, or at the same time, they are cutting in/out independently from each other. Sometimes twice in a 10 second period, other times not at all for 20 min or so.
      My Computer


  2. Posts : 6
    Windows 7 (64 bit Home Premium)
    Thread Starter
       #2

    I should add that the motherboard was bought at the same time as Windows 7.
      My Computer


  3. Posts : 6
    Windows 7 (64 bit Home Premium)
    Thread Starter
       #3

    No one has a clue to any suggestions on how to narrow down my problem?
      My Computer


  4. Posts : 208
    Windows 7 Home Premium x64
       #4

    Could you report any conflicts in Device Manager?
      My Computer


  5. Posts : 6
    Windows 7 (64 bit Home Premium)
    Thread Starter
       #5

    IIllytch321 said:
    Could you report any conflicts in Device Manager?
    I expanded all the devices in the device Manager, including hidden ones, and no conflicts anywhere.
      My Computer


  6. Posts : 208
    Windows 7 Home Premium x64
       #6

    I'm lost; sure the drivers couldn't be re-examined? You get a software cd with the motherboard? Should have drivers on it if you didn't already take care of that. I just don't see Windows as the cause of the problems.

    When you plugged the mouse into the keyboard's USB, what exactly changed?

    Maybe you vomited somewhere in the BIOS prior to your disabling of the onboard audio and mucked something up?
      My Computer


  7. Posts : 6
    Windows 7 (64 bit Home Premium)
    Thread Starter
       #7

    IIllytch321 said:
    I'm lost; sure the drivers couldn't be re-examined? You get a software cd with the motherboard? Should have drivers on it if you didn't already take care of that. I just don't see Windows as the cause of the problems.

    When you plugged the mouse into the keyboard's USB, what exactly changed?

    Maybe you vomited somewhere in the BIOS prior to your disabling of the onboard audio and mucked something up?
    Nah. I reset the BIOS to default because Windows seemed to be having problems when I was first trying to install it. My motherboard and Windows are both new, and bought in November. Now that you mention it, i have been listening more closely, and I'm not hearing the audio drop out any more, like it did with the onboard audio.

    The change from plugging the mouse into the keyboard seemed like it helped reduce the problem, and since you asked, I played around trying to see if there was a real difference, and i can't really tell for sure either way, because the disconnects are so sporadic. Sometimes the mouse will disconnect 10 times in an hour, other times it will not disconnect at all for two hours. It's a real pain.

    Is there a way to see what IRQ or DMA is assigned to the mouse, so i can see if the computer is actually changing them, after it disconnects again?
      My Computer


  8. Posts : 208
    Windows 7 Home Premium x64
       #8

    Do a Windows search for "msinfo32" run the .exe that pops up, expand "Hardware Resources" on the left, and there you go.
      My Computer


  9. Posts : 10
    Windows 7 ultimate 64bit
       #9

    I had the same problem with a standard Logitech mouse on a USB port of an ASUS board with Windows 7 running.
    This problem with USB mice seems to be very frequent, because I found many reports about that in many forums.
    I tried all the software solutions poposed in these forums but to absolutely no avail. On the contrary, the mouse freezing for some seconds with the "USB device connect/disconnect" sounds happened more and more frequently.

    Finally I found the very simple solution:
    It is a simple hardware problem and had nothing to do with software:

    The Logitech mice (and their various similarly constructed clones) have an extremely cheap cable connection. The relative thin and cheap cable has no antikink device at all. The only strain relief is an S-shaped channel through which the cable is lead into mouse case. Obviously the isolations of the wires inside the cable are chafed in the kinks of the S-shaped channel after longer use so thin, that tottering short circuits happen between the wires in the cable, which appear to the system like connecting and disconnecting the USB device.

    I screwed the mouse encasement open and took the cable out of the S-shaped channel and bend it straight thus removing all kinks in it. Then I shoved the cable one inch into the case. so that I could lay a "fresh" (= unkinked before) section of the cable into the S-shaped channel.

    I did that 2 weeks ago. I had no problems since then anymore.

    Werner

    P.S.: Be careful opening the mouse case:
    Remove the single screw which holds the case closed.
    Then lay the mouse on a table while you take off the cover of the case and keep it lying on the table while you do the above described operations with cable and close the case again before you lift it off the table.

    By this you prevent that the mouse wheel falls out of its position, cause it is a lot of enervating hustle to put the wheel and the 2 spring wires holding it back into correct position, if you don't know how to do it. So better keep it untouched in its position while you do the cable operations.
      My Computer


  10. Posts : 6
    Windows 7 (64 bit Home Premium)
    Thread Starter
       #10

    I bought a new mouse, which fixed the problem for me. However, this new mouse is flaky, and I may just try your solution. :) I did try wiggling the cable to see it I could duplicate the problem, but it did not.
      My Computer


 
Page 1 of 2 12 LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 17:59.
Find Us