New 5TB WD Green EZRX HDD only showing 561GB capacity

Hey CK_WD,

Thanks for your response! I'm pretty confused by the whole situation as well...

I've had a look at the screenshot and it does say 5000.00G - what I would expect for a 5TB drive. I do apologise for the blurry picture but that screen is only displayed for half a second and the shutter speeds on smartphones are notoriously slow.

I'll run WD Align when I return home... Do you think there is anything else I can try? I'm puzzled that in the BIOS, during POST, and from within WD's diagnostic utility (see screenshot below), it states that the drive should be 5TB in size. I've even tried to extend the volume in CMD via diskpart who no luck.

Hi there

Check the BIOS -- for large volumes you might have to set the settings to LBA (older BIOSES couldn't calculate nr of sectors etc on these large volumes so they did a sort of "fiddle trick" known as LBA) .

You also will need to convert the HDD to GPT. Note that W7 cannot boot from a GPT HDD (not 100% sure about that one but I'm sure I read about it somewhere. - I use an SSD for my OS drive so the issue doesn't arise).

Convert the HDD with an elevated command prompt

Diskpart
Select disx xxx
clean
convert GPT

Now you should be able to view it in the system and start creating partitions on it.

I'm surprised the screenshot shows for example 3000GB - normally windows will show say something like 2.81TB.

Cheers
jimbo

The Gigabyte Tech Support seems to have said :

"Dear customer,

Unfortunately GA-MA785GMT-UD2H was old chipset board use Award bios which only be able support up to 2TB capacity drives.

Best regards,

Gigabyte technical support team."

However this user in March 2014 said:

"I had been using an old driver. With a newer driver, the issue is solved, and the full 4TB drive is now seen.

The version of the AMD SATA driver that does not see it is dated 05/05/2009 with version 1.2.0.125. (That's the one you currently get if you download from the MA785GMT page on USA site.)

But, on the general downloads section of the gigabyte website, NOT on the support page specific to the MA785GMT motherboard, there is a newer driver dated 10/12/2012, version 1.21.337.

After updating to this newer driver, all is well."

The driver mentioned is the AMD Sata Controller driver.
Can onboard SATA of MA785GMT-UD2h see a 4TB hard drive (AHCI) ?

So search for the new driver install it and then check.

Please create a System Restore point before you make any changes so that if need be, you can roll back.

Good Luck.

EDIT: As jimbo45 opined a BIOS update may also help. But first try the SATA Controller driver update.

Hi Everyone,

Success!

As I wasn't able to find the newer SATA Controller driver from the Gigabyte website, I uninstalled the AMD AHCI driver and used the default Windows AHCI driver. The full capacity of the 5TB drive is now unlocked

Thank you very much for your time and I hope this thread can help someone in the future.

Glad that I could lead you to resolve the problem.:)