board has 4 dimm slots and it looks like can handle 4gb?
The S875WP1-E server board contains four 184-pin DIMM sockets and supports up to four DDR
SDRAM DIMMs. The minimum supported memory configuration is 128 MB and the maximum
configurable memory size is 4 GB with stacked unbuffered DDR266/333/400 ECC DIMMs.
Supported memory configurations are as follows:
• Up to four dual-channel 184-pin Double Data Rate (DDR) SDRAM DIMMs connectors with
gold-plated contacts. Supported memory configuration are:
DDR400: to run DDR400 memory at full speed requires an Intel Pentium 4 processor
with 800 MHz front side bus (FSB) frequency.
DDR333: to run DDR333 memory at full speed requires an Intel Pentium 4 processor
with 533 MHz FSB frequency. DDR333 memory will run at 320 MHz frequency when
using an Intel Pentium 4 processor with 800 MHz FSB frequency.
DDR266: DDR266 memory may only be used with an Intel Pentium 4 processor with
400 MHz or 533 MHz FSB frequency only.
• Support for:
Unbuffered, single or double-sided DIMMs
Serial Presence Detect (SPD) memory only
Support for Suspend to RAM (STR), S3 ACPI state
ECC and non-ECC RAM
2.5 V memory
Support for 128 Mb, 256 Mb, and 512 Mb memory technologies for the following memory
Up to 1.0 GB utilizing 128 Mb technology
Up to 2.0 GB utilizing 256 Mb technology
Up to 4.0 GB utilizing 512 Mb technology
Only DIMMs tested and qualified by Intel or a designated memory test vendor will be supported on
the S875WP1-E server board. Note that all DIMMs are supported by design, but only fully
qualified DIMMs will be supported. Mixed mode DDR DS-DIMMs (x8 and x16 on the same
DIMM) is not supported. Check the Intel Customer Support website for the latest tested memory
So can I buy 4, 1gb ddr 400 memory modules and it will show as 4gb?