Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: WD's Data Lifeguard Diagnostics: Too many bad sectors detected

18 Apr 2014   #1
sueling

Windows 7 Home Premium 64bit
 
 
WD's Data Lifeguard Diagnostics: Too many bad sectors detected

Western Digital - My Passport Essential SE 1 TB USB 3.0 (WDBACX0010​BBK-01)
* The external hard drive was purchased in 2011.
* It was working fine before. I stopped using it for.. 2 months? Recently, I started using it again.. only to experience this problem.
* I've tested the external hard drive on my home laptop and office desktop PC. Experienced the same problems, as listed below:

(0) WD's Data Lifeguard Diagnostics: "Too many bad sectors detected" message, as seen in attachment
(1) Devices & Printers - "My Passport 0740" is detected
(2) My Computer - Sometimes it shows G: drive, sometimes not at all
(3) Partition Wizard - "Bad drive" message
(4) Disk Management -
* If you plug in the external hard drive, and then start Disk Management... only "Connecting to Virtual Service" message.
*If you start Disk Management, and then plug in the external hard drive, "Disk 1 Unknown 931.48 GB Not Initialized; 931.48 GB Unallocated"
(5) Internet: The internet won't work with the external hard drive plugged in
(6) Other programmes: Sometimes programmes will hang with the external hard drive plugged in

Could someone please help with this problem? I have a lot of important data stored inside.
Thank you!




Attached Thumbnails
WD's Data Lifeguard Diagnostics: Too many bad sectors detected-test-results-quick-extended-test.jpg  
My System SpecsSystem Spec
.
18 Apr 2014   #2
jumanji

Windows 7 Home Premium 32 bit
 
 

Your drive is galloping towards its end and there is nothing much you can do to stop it - that's my guess that I hope is not true/does not come true.

Stop using the drive further and get into data recovery mode. With the drive constantly creating more and more bad sectors some or most of your data may already be corrupt. Nonetheless try to recover whatever you can.

Use PhotoRec for data recovery. It can recover data even if the file system is corrupt.

Guide to using PhotoRec recovery software.

Keep another external drive connected to copy whatever you can recover before running PhotoRec.

As far as copying the found files see my post here My external hard drive suddenly became unllocated: ( Though I had mentioned it for TestDisk the same procedure applies to PhotoRec too)

Good luck.

( Long blackout. I am typing in the dark with the inverter supply to the comp. Shutting down comp now to put lights on.)
My System SpecsSystem Spec
18 Apr 2014   #3
essenbe

Windows 7 Enterprise X64/Windows 10 Enterprise X64/Windows 10 Pro X64/Linux Mint
 
 

Sueling, I'm sure you are aware that Data Lifeguard is Western Digitals diagnostic tool. If it says the drive is/has failed, I would get my files off as soon as possible. For most any program to recover files, the drive has to be recognized. You can try Copy & Paste - in Windows Recovery Console . If that will not work, sometimes Linux reads drives a little different than Windows so you could try Emergency Kit - save your files from a dead OS.

Failing that, you may try Recuva. It is probably the best recovery program I am aware of. I hope some of this helps.
My System SpecsSystem Spec
.

19 Apr 2014   #4
sueling

Windows 7 Home Premium 64bit
 
 

Thank you for your replies. I'll give jumanji & essenbe's suggestions a try tomorrow.
My System SpecsSystem Spec
23 Apr 2014   #5
sueling

Windows 7 Home Premium 64bit
 
 

I just bought a new external hard drive, to copy over the files.

I'm going to try TestDisk first.

Do I need to format it before using? It's a Samsung M3 Portable 1 TB USB 3.0.

I have yet to install the bundled software. I don't plan on using Samsung Drive Manager, and will keep it on a CD-R. Is this a good idea?
My System SpecsSystem Spec
23 Apr 2014   #6
jumanji

Windows 7 Home Premium 32 bit
 
 

1. You need not format your new drive. It would have already been formatted. Just copy a small file to it and check everything is Ok.

2. You need not waste one CD-R to copy any crap/scrap that came with the new drive. Just copy all that into a folder on your internal drive just in case you need it later. After copying delete all folders/ files on the new drive including any test writes you did.( Do a Shift+Del to send those into a black hole)

3. Suggest that you try Recuva first as suggested by essenbe - though I don't pin any hopes on it.

4. Try PhotoRec in TestDisk instead of TestDisk itself. PhotoRec is much safer. Again I do not pin much hopes on it given the condition of your hard drive as stated by you. But yet we are compelled to try our luck hoping to scrape atleast something out of it.

Good luck.
My System SpecsSystem Spec
23 Apr 2014   #7
Britton30
Microsoft MVP

Windows 7 Ultimate X64 SP1
 
 

Aside from the good suggestions already given, I also would not install anything from the drive's CD. Those external drive program can often cause more trouble than being useful.
My System SpecsSystem Spec
24 Apr 2014   #8
sueling

Windows 7 Home Premium 64bit
 
 

I followed your advice, and Shift + Delete the bundled software from Samsung.

My Computer: Western Digital doesn't show up here.
Recuva: Western Digital appears as Drive H; failed to scan due to "Warning: Unable to open drive".


Attached Thumbnails
WD's Data Lifeguard Diagnostics: Too many bad sectors detected-recuva_popup.jpg  
My System SpecsSystem Spec
24 Apr 2014   #9
jumanji

Windows 7 Home Premium 32 bit
 
 

Ok. Try PhotoRec as suggested in post #2.

If it could recognise the drive there is a fair chance of some recovery. ( I take this cue since Recuva did find the drive but could not open.)
My System SpecsSystem Spec
25 Apr 2014   #10
sueling

Windows 7 Home Premium 64bit
 
 

Um, from what I understand, the first step is to reformat the external hard drive and then run PhotoRec. You don't need to clone the external hard drive first?
My System SpecsSystem Spec
Reply

 WD's Data Lifeguard Diagnostics: Too many bad sectors detected




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
recover data from corrupted or bad sectors seagate portable hdd
hi, i have a seagate portable external hdd, haven't been used for 6 months, i connected now, it prompts as "scan and fix or continue without scanning". if i start scan and fix, it goes till some extent and stops and disconnects. sometimes it even prompts as ""windows cannot access the disk"". i...
Backup and Restore
Hard disk not detected on diagnostics by boot menu
Hello, everyone On switching on my laptop, the below written text displayed on screen Intel UNDI , pxi-2.1 (build 083) Copyright (C) 1997-2000 intel corporation This Product is covered by one or more of the following patents: US5,307,459, US5,434,872, US5,732,094, US6,570,884,...
Hardware & Devices
Can't find hard drive in hd lifeguard
I have had some issues installing windows 7 it's not letting me format the disk from the installation disk. It keeps giving me an error when I try to format ,and my hard drive just shows up as unacollated space. I tried to run he lifeguard to see what the issue was but my hard drive doesn't show in...
Hardware & Devices
Failing hdd or bad sectors, will not boot, how to recover data?
Long story short I shipped a lenovo x220 for mobo repacement with the HDD. I got it back, but windows bsod on boot. I found out this was a conflicting driver issue due to the new motherboard, so I used a tool in hires boot CD to resetthe hard disk controller or something like that. Win 7 then...
General Discussion
Hard drive only six months old, 29 data sectors reallocated
I bought this hard drive (Hitachi travelstar 1tb 7200 rpm) in may of this year 2013. When I replaced it, I lost one of the screws that attaches to the mylar cover that goes into the hard drive securing the cover in place, but I replaced it with another screw from a different laptop hd enclosure. ...
Hardware & Devices
Hard Drive diagnostics report bad sectors
Hello, I am having serious corruption problems with my hard drive. I have reinstalled windows a few times now, but it always ends up being unable to boot. At the moment, my computer cannot even boot up in normal or safe mode, all my restore points have been deleted, and startup repair cannot do...
Performance & Maintenance


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 23:03.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App