Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Windows 7 unable to read external drive formatted FAT32

10 Nov 2009   #1
Sunitalynn

Windows 7
 
 
Windows 7 unable to read external drive formatted FAT32

I have an external drive that was formatted FAT32 which I have been using with my XP laptop for the past year. I have data on it that I want to transfer to my Windows 7 laptop. However, as soon as I connect it to my Windows 7 laptop, it comes up with a message saying "You need to format the disk before you can use it. Do you want to format it?" I assumed that Windows 7 was unable to read the drive because it was FAT32, so I connected it back to my XP laptop and ran the conversion: CONVERT E: /FS:NTFS - The conversion completed successfully and I connected the drive back to my Windows 7 laptop. But it still came up with the same message that the drive needs to be formatted. Does anyone know what the problem could be?


My System SpecsSystem Spec
.
08 Dec 2010   #2
TGNetwork

Windows 7 Ultimate 64-Bit
 
 

What I would do, is format the drive using Windows 7 then copy the files with your XP then copy them over to your 7. Windows 7 uses NTFS system while XP can use both so if the drive is formatted with 7 then XP can backwards convert it. Windows 7 kinda sucks when it comes to accessing drives. I don't know why they did that but oh well.....
My System SpecsSystem Spec
08 Dec 2010   #3
Bill2

Windows 7 x64 pro/ Windows 7 x86 Pro/ XP SP3 x86
 
 

Theres no issue with win7 reading fat32 usb drives. The "Do you want to format it?" is a well-known nag that mostly happens because the drive is flagged dirty for some reason, maybe because it was yanked off instead of being ejected properly.

You're lucky, XP can read the data. Just copy the data over to the hard drive, then format the drive in win7- fat32 would be perfectly fine. After that copy the data over to the win7 computer.

USB drives can be optimized either for quick removal or for performance. If you're the yanking out types, set it for quick removal.

How to Optimize Your Flash Drive for Quick and Safe Removal | eHow.com
My System SpecsSystem Spec
.

08 Dec 2010   #4
Night Hawk

W7 Ultimate x64/W10 Pro x64 dual boot main build-remote pc W10 Pro x64 Insider Preview/W7 Pro x64
 
 

I doubt the OP will reply since this thread is over a year old. As far as having 7 recognise the Fat 32 volume on any external drive when first plugged in you would take a fast trip into the Disk Management tool and use the Add New Volume wizard which will likely be seen first when going to right click on the drive to use the change drive letter option. http://www.sevenforums.com/tutorials...ndows-7-a.html
My System SpecsSystem Spec
08 Dec 2010   #5
TGNetwork

Windows 7 Ultimate 64-Bit
 
 

So... If WIn 7 has no problem with FAT then how come it can't read either of my two FAT Hard drives? The Problem is not that Windows just recognized a "Dirty Drive" it recognizes them fine but you can't access them. If you look in device manager, yes they show up but you cant access them in any way. They Don't show up on MY computer and since they have no assigned drive letter you can't manually tyoe in an address. Microsoft just dropped the ball the last few years making everything only posible their way and no other way will work.
My System SpecsSystem Spec
08 Dec 2010   #6
Night Hawk

W7 Ultimate x64/W10 Pro x64 dual boot main build-remote pc W10 Pro x64 Insider Preview/W7 Pro x64
 
 

First you have to go into the Disk Management tool whenever adding on any new drive or device like a flash in order to initialize the drive or device there. 7 will read and write to Fat 32 volumes since MS returned Fat support with the new version due to flash drives along with the use of external drives.

External hard drives boxed as Windows/Mac compatible will come with a factory Fat 32 volume or the new exFat in order to be cross platform. Drives intended for Windows only the way they are packaged will see NTFS being native to 2000 through W7. Flash drives come with Fat by default to available for use on most OSs.

Once in the DM and you right click on the drive or device seen there you will likely see the Add New Volume prompt appear like the image attached here. That will take you through the steps of selecting the mbr or guid type partition info as well as selecting the drive letter available to be assigned.

Once that is seen to the auto play prompt flashing may be seen as the drive is then listed in Windows Explorer with that same drive letter. If the volume has been corrupted somehow then a reformat would be necessary while a good partition table will see immediate access.

For a flash drive or memory card you would find that under removable storage while an external hard drive will be mixed in along with the internal drives. The other image shows a look at a usb flash drive with Fat 32 as the file system viewing the iso for a Linux distro written to it. Note the properites screen in particular showing on the 64bit 7 Ultimate here.


Attached Thumbnails
-fat32-available-64bit-windows-7.jpg  
Attached Images
 
My System SpecsSystem Spec
24 Aug 2012   #7
balak46

Windows 7 Ultimate x64
 
 
Win7 will read FAT32. - Yipper.

Solutions are simple. Go methodical. Eliminate one by one.
Try these:

1. Plug into the USB port at the back of the computer. Why? Some drives like the 'direct' connection than some circutous route to get to reading the drive.

2. Change the USB cable. Try another one if you have it. You may laugh. It worked for me. As simple as that. Sometimes solutions are simple and they are staring at you and we tend to miss it. LOL

3. Go to Devices and Printers (control panel). See if your drive shows up there. Right click, open. You now can read files.

4. Start ->Mycomputer->Rightclick-> Manage ->System->diskmanage. See if your drive shows up without a letter. Assign a letter and it will work.

So there you have it. One of the 4 solutions will work. Trust me, WIN7 will read FAT32. No question about that. MS built it to be backward compatible.
My System SpecsSystem Spec
Reply

 Windows 7 unable to read external drive formatted FAT32




Thread Tools




Similar help and support threads
Thread Forum
How to read FAT32 formatted external drive on Windows 7?
I had a DVD recorder with internal HDD (Nortek, ndvx hd 160 p). It was repaired once, but the second time it stopped working, the repairer said the vendor didn't longer provide spare parts. I asked him to give me the HDD back as I had downloaded tons of home made movie of my kids from a...
General Discussion
Is it possible to install windows 7 from a FAT32 formatted usb drive?
I'm currently trying to install windows 7 from a usb on my laptop, however I seem to have a strange issue - when I go to set the boot priority in my BIOS, it does not list any NTFS formatted usb drives as boot options. I've tried this with multiple usb drives formatting them to both NTFS and FAT32:...
Installation & Setup
Formatted External HD as exFat - Windows does not read drive...
Hey folks, I just reformatted a 350gig external hard drive as exFat so as to be able to use it with both Windows at home as well as Mac's - but now it seems my laptop does not read the drive ie I can't see it in MyComputer - although I can still safely remove for some reason. :confused: I...
Hardware & Devices
Can't read Mac-formatted FAT32 flash drive
I formatted a 64gb flash memory stick on a Mac with MSDOS/FAT32 format and copied some files to it just fine. When I plug the stick into my Windows 7 64 bit machine, it wants to format it! From what I have read, the Mac formatted it using a GUID partition. I can see it in Disk Manager and there are...
Hardware & Devices
formatted an external to fat32
i have a ps3, so i formatted my exHDD to fat32, & it worked on both (my laptop & ps3) fine, than i go out of town for a week, & take my pc. I update it while im gone, once i get back the ps3 reads the HDD but my pc says it is in RAW format, & says it need s to be formatted. it gives it a drive...
Hardware & Devices
External HDD WIN7 Formatted XP can't read it...
Hi Please accept my appologies if this is a known and solved issue that I haven't found yet. I formatted my Western Digital 500GB My Book with Windows 7 RC and copied all my data across my network from my mac's external HDD. I'm sure I formatted it in NTFS and not the new Windows7 FAT32...
Hardware & Devices


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 00:27.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App