New
#11
I just went on to their website and had a look at the type of file it is.
It seems you just burn all 3 files to a disk, boot from disk and it should go through from there as the .BAT file that's in it just runs the .exe program then then .ROM, and then it loads the new BIOS and restarts.
I read the instructions on the Foxconn website as well, and it goes on about typing all this crap. You shouldn't need to do that as all of them are in the .BAT file, which will run when you boot from the disk.
Also flash the CMOS as well with the jumper pin on the motherboard, for good measure.