New
#1
ACHI Problems
Okay, my system is accurate under my profile...so on with my question. Thanks again to this forum, it has been a lifesaver!
I just got the Corsair 800D case. One of the features is the Hot Swappable drive bays in the front. I thought I had previously enabled AHCI but I enabled AHCI for the GSATA not the SATA. So now that it is set right, I put my C drive in the 1st hot swappable drive bay, which plugs into Sata0, then the second one, I put a 1TB WD Black Sata drive which plugs into Sata1 on the board respectively.
Once I got into Windows 7, the OS started installing the drivers which took about 2 minutes, then it finished. I removed the secondary HD from bay 2 (sata1) after using "safley remove hardware" to stop the drive. All went find. about 2 minutes later, I plug it back into the same bay, the computer then restarts without warning. It consistently does this and I am not sure why. The computer also acts very buggy, takes a long time to boot up, and just acts strange...where should I start as far as diagnosing the problem?
Any suggestions would be greatly appreciated.
Zach
Last edited by morrowmedia; 17 Jun 2010 at 20:00. Reason: misspelled AHCI corrected them.