New
#11
Yes since those are the only missing.
Yes since those are the only missing.
Ok, thanks.
I did that and now when I reboot I get:
Intel Undi, pxe-2.1 (build 082)
copyright...
covered by .....
realtek pci....
pxe-ec8: !pxe structure was not found in UNDI driver code segment.
pxe-m0f: exiting pxe rom.
reboot and select proper boot device
or insert boot media in selected boot device and press a key
Does PW CD now show the partitions restored to the drive map?
Which partition is marked System and/or Active.
Try Rebuild MBR from Disk tab, Apply, reboot.
None were marked active
i made the os_install active, others say status=none
all types are primary
i did a rebuild and the boot menu comes up like it used to but next screen when choosing 7 says there is an error failed to start...recent hardware or softwrae change.
status 0xc0000000e
the boot selection failed because a required device is inaccessible
Does the Win7 partition retain its correct drive letter? Rightclick Explore to see if files are intact.
Next run Rebuild MBR from Disk tab, Apply, reboot.
If it doesn't start, boot into Win7 DVD Repair console or Repair CD to run Startup Repair up to 3 times to write the System MBR to Win7 partition.
Wow you are great. I think it's all working! It's late so I'll check it all out tomorrow. Thanks again for all you did.
Sounds good.
I would next run SFC /SCANNOW Command - System File Checker to check OS integrity, then Disk Check to check HD file system integrity.
Then watch performance closely. Here are troubleshooting tips: Computer lags every couple seconds