Boot manger located on old drive

When i installed windows I made the mistake of leaving all my old drives plugged in, as such the boot manager for my current windows os is located on my old failing drive(disk 1). From this image Attachment 164385 you can see that the boot manager is located on disk 1 on the system reserved section. I need to move/install/repair it to the SSD drive (disk 3/C drive). However after trying the a few ways i am at a loss what to do.
What i have tried

1. Disconnecting all the other drives and running windows repair off the windows disc 4 times
2. Marking the SSD drive as active get this error Attachment 164386 sorry for the fuzzy picture it says "the specified partition is not valid for this operation" i used this guide

HTML Code:

https://www.sevenforums.com/tutorials/71432-partition-mark-active.html?ltr=P

I tried both ways inside cmd off the windows disc and through disk management.
3. converting the ssd from a logical drive to a primary drive using Easeus partition manager
4. resizing the partition to create unallocated space to create into a primary partition agian using Easeus partition manager, wouldn't resize

As i understand it the problem may be that the SSD is a "logical drive" and not a primary one as reported by windows as that's the only difference i can see, if this is the case can it be fixed? ( I need to reformat disk 1 hence the need to move the boot manager)

Any ideas?

edit: images Disk management


error message

HOW TO POST A SNAPSHOT OF DISK MANAGEMENT DISPLAY

Run disk management:
WIN | type DISKMGMT.MSC | ENTER
WIN is the key with the wavy flag.

Maximize the output of Disk Management:
ALT-Spacebar key combo (this pops up a menu) |
X key (selects Maximize) |
Drag the field separators (such as between Status and Capacity) to show entire field. This is very important, otherwise, needed info is not visible.

Make a snapshot:
WIN | type SNIPPING | ENTER
Click the New button.
Drag the cursor around the area you want to snip.
File | Save as | select save location and name | Save button

Post the snapshot:
· Click on the paperclip icon in that row of icons at the top of the message box.
· Click on a BROWSE button. There are 5 of them.
· Navigate to the folder containing the snapshot.
· Click on the snapshot.
· Click on the OPEN button.
· Click on the UPLOAD button adjacent to the 5th BROWSE button.
· Close the MANAGE ATTACHMENTS window.
· Position the cursor at the spot in the message where you want the
snapshot to appear.
· Click on the PaperClip again.
· Click on the file which you want to insert
· Attach code will be inserted into your message.

You may care to do more than a simple format to the old HDD, have a look through the information presented in these tutorials linked below.

Secure Erase / Wipe : Definition and Methods

Additional Secure Erase / Wipe Information