So had a working old board, chip and memory home. Needed to setup another machine for other purposes. Bought a little cheap case.
Mushkin 2GB (2X1GB) DDR2 667
Intel Pentium 4 630 3.0GHZ
Stock fan + heatsink
So i set everything up as normal with hdd's connected.
The board gets power. ( The power light on it is lit)
The GPU gets power. ( The fan is spinning)
The Heatsink and fan gets power ( The fan is spinning )
But I get no display.
D/c'd the hdd's and cd rom drive and tried again, same thing.
Tried with one stick of ram, with no ram. Same thing
Removed the Heatsink and fan to make sure the chip was working. It was getting hot so yes, it was.
Tried the GPU in another machine, it works.
Reset CMOS Battery.
Tried it out of the case, same thing.
Tried a diff PSU, blew a resistor.. lol.. oops..
Kept trying but.. that's about it...Everything is showing signs of power but no display.
The only think I could think left of is the PSU.
Also,the board has a 8pin CPU power connector. Only got 4 pins plugged in there..
I'm pretty much out of ideas here, so now I turn to you guys.
Anyhelp is much appreciated. Thanks in advance.
P.S - I used to use these parts before, so I know they are working. Probably just been idle for some months in a box.. under my bed.. somewhere >_>