New
#1
Can't boot into original OS after dual boot configuration
Hi Everyone,
I recently added a hard drive to my computer (SSD), and installed Windows 7 x64 onto it. The result being a dual boot system, which by default boots to the SSD, and optionally (by Windows Boot Menu), can be booted to the original drive (standard mechanical drive).
Initial setup went fine, however I decided to customize the Windows Boot Menu, so that logical names could be associated with each operating system instance. To do this I used EasyBCD and I altered the names in the Windows Boot Menu from:
to...Windows 7
Windows 7
Shortly after the modification I noticed that I was no longer able to boot into the original OS. Instead I was being presented with a "Repair Windows" option. Figuring that my EasyBCD "tampering" may have had something to do with the issue I decided to change the names back to "Windows 7" in the Windows Boot Menu. However doing so had no positive impact on boot up of the original OS.Windows 7 - SSD
Windows 7 - Standard Drive
After booting again into the original OS I accepted the "Repair Windows" option, and then left the computer over night to do it's "thing". After completion of the "Repair" the situation has deteriorated -
* Windows doesn't load (the same as before)
* Windows doesn't present a "Repair Windows" option (it did before)
* The computer reboots a short period after the "Starting Windows" screen is presented
As a side note the drive is in good health, and all data on it can be read from within Windows 7 when I boot to the SSD OS.
If anybody has any ideas of how I can fix my computer so that I can boot into both operating systems again they will be greatly appreciated.
Kind Regards,
Davo