Windows 7 clean install problem "Power save mode"

Hi all,

I have ran into the strangest problem while completing a fresh install of Windows 7. I had previously had Vista ultimate 64bit installed but decided to install Windows 7. The first time I did the install I decided NOT to format the vista partition, but to rather just install over it. I was using Windows 7 for about a month when I decided to get rid of all the Windows.old files (vista install) and do a fresh format.

I entered the Windows 7 install, FORMATTED the old partition which had the previous installation on it and chose a clean install. The whole process was slow but it ended up installing fine until the first reboot came around. The windows 7 logo came up but then the screen just displayed with " Power save mode on" and the green light on my monitor turned orange and it hasn't gotten further since.

I have tried to format and do the install again but it gets to the same point, the installation seems to be fine until the first reboot where the screen goes into power save mode after the windows 7 logo is displayed.. This seems strange as the ISO I used to do my initial install worked fine, but on a fresh install after format it wont work. I tried to boot into safe mode but it says it cannot load safe mode without the installation being complete.

Anyone ran into the same problem? Thanks in advance.

I have ran into the strangest problem while completing a fresh install of Windows 7. I had previously had Vista ultimate 64bit installed but decided to install Windows 7. The first time I did the install I decided NOT to format the vista partition, but to rather just install over it. I was using Windows 7 for about a month when I decided to get rid of all the Windows.old files (vista install) and do a fresh format.

to start with all you had to do was open my computer -> check properties of C:\ -> click cleanup -> advanced -> and clean prior installs of old windows versions. (it is in the manual).

Power save mode: are you using a LAPTOP? If yes, make sure the AC Adapter is plugged in. (that is in the manual also.)

I have tried to format and do the install again

tried to format? exactly what do you mean I tried? what did you format to: fat16, fat32 or NTFS? what format command did you use.? what version of Win 7 are you trying to install?
fill in your complete system specs. all the info you can give will really assist.

Updated my system specs.

1. I am not using a laptop, it is a desktop which has Win7 previously installed.
2. When I say "I tried to format", I did indeed format. Under custom installation in the Win7 menu I selected the disk and formatted it under disk options.
3. The version of Win 7 is Ultimate 64bit.

Thanks for your quick response.

It just seems strange that when I had previously installed Win7 over my vista installation it worked fine, but now that I have formatted that partition and tried a clean install it wont work.