Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: EFI system partition on wrong drive

04 Feb 2015   #1
coinup

7 64bit Ultimate
 
 
EFI system partition on wrong drive

EFI system partition on wrong drive-comp-manage.jpg

How do I get the efi partition on the c:\ drive????




My System SpecsSystem Spec
.
04 Feb 2015   #2
cluberti

Windows 10 Pro x64
 
 

First, volume letters != drive letters. Unless you pre-partition and image yourself, Windows setup will place the EFI partition on the first physical disk presented to setup by the EFI OS, even if it's not actually the first disk installed into the system. I used to get this all the time with an older Asus board, where my (larger) storage volume would get the EFI partition, even though I chose a different physical disk to place the installation volume on. I ended up backing up my data and moving the SATA cables around until it was the way I wanted it (and no, it didn't match the port layout on the motherboard unless I set the Intel ICH configuration from "RAID" to "AHCI".
My System SpecsSystem Spec
04 Feb 2015   #3
gregrocker

 

This is why all other drives should always be unplugged during any Install or Startup Repair.

To put all of these necessary UEFI partitions on the same drive I would install flexible Macrium Imaging - Windows 7 Help Forums to C and have it save a backup image of the partitions required to boot including EFI System Partition, possible hidden MSR partition, and C. Do not include any of the other partitions in the image.

Then boot the Macrium boot disk you've created to Recover from the image, drag the necessary partitions to the target drive after deleting C using the link on the Recovery page. It should automatically adjust C size but you can manually adjust that using the link it creates under the partition once dragged to the target drive.

Now boot into BIOS setup and set the Win7 drive to boot first instead of the old EFI System drive, Save and Exit to boot Win7.

If for any reason Win7 won't boot, unplug all other drives to boot into the Win7 disk or System Repair Disk to run Startup Repair. Afterwards I would plug Disk0 cable into the Win7 drive so it is in first position where future repairs cannot derail the System partition again.

In the unlikely event this fails, you'll still have the old EFI System partition on the other drive to boot the C image by setting it first to boot in BIOS. Don't let it get set first to boot again otherwise.

Finally, none of those other drive partitions should be marked Active which is only used to flag a drive intended to boot an OS on an MBR disk, so mark them Inactive if they are not there for that purpose alone: Partition - Mark as Inactive - Windows 7 Forums
My System SpecsSystem Spec
.

Reply

 EFI system partition on wrong drive




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
BOOTMGR is on the wrong drive? Partition marked as SYSTEM
Hello all, Just got a new motherboard yesterday so I hooked it all up, connected the SATA hard drives in the same position ports on the new motherboard as they were on the old one. Re-installed WIndows 7, and it's working fine. Installed onto C:\ which is correct, however I noticed that the 'boot'...
Installation & Setup
System Partition on Wrong Disk
So, I installed 64 bit Windows 7 on my computer, all seems good except the system paritition is not on the disk I installed Windows 7 to. I can not get inside the computer to remove one hard drive and then reinstall and I would prefer not to even reinstall again. Disk E is my USB Stick. Is...
Installation & Setup
System Partition created on the wrong Disk
First of all, I would like to say, Windows Installer needs A LOT of work. Too buggy. My problem: I have DIsk 0 (500 GB), and DIsk 1 (250 GB). These are seperate HD, not partitions. I have installed Windows 7 on Disk 0. However, the dumbass windows created the System partition on Disk 1. ...
Installation & Setup
How to Avoid Placing System Reserved Partition on Wrong Hard Drive?
Hi guys, I want to do a clean install of Windows 7 Home Premium on my HP Envy 17 laptop in order to get rid of bloatware. The problem is that my laptop has two identical 300GB hard drives, so it is virtually impossible to distinguish them at the drive options window during...
Installation & Setup
System Reserved partition on wrong drive.
Hello, I recently bought a SSD to install my OS on it and use my HDD for other files. But when I tried to install the OS with only the SSD, it gave me an error: “No bootable partition” Then I tried with my HDD and SSD together and then it gave me the error: “Cannot boot from cd: code 5” So...
Installation & Setup
System Reserved partition on wrong drive - how do I move it?
Hi, here's a screenshot of my drive setup: http://dl.dropbox.com/u/13583891/Diskmgr.jpg Now, the problem is (apart from me being an idiot!) is that when I installed Win 7 onto Disk 2 (my SSD disk), I didn't disconnect the other two drives from the machine. Therefore the System Reserved...
Installation & Setup


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd

All times are GMT -5. The time now is 11:34.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App