AP working, but can't connect to device


  1. wcsjohn
    Posts : 13
    Windows Vista
       New #1

    AP working, but can't connect to device


    I'm using a D-Link DIR-655 as an AP after a Cisco router. It works and everything is configured. However, I can't seem to log into the device admin. I can get a list of all devices connected by IP from the Cisco box, but nothing comes up when I type the IP's into a browser. Tried http and https. Any ideas? This is driving me crazy.

    Update: It is just a bridge, so assigned DHCP addresses are from the Cisco router.
      My Computer
    Quote Quote

  3. wcsjohn
    Posts : 13
    Windows Vista
    Thread Starter
       New #2

    Fixed. Finally guessed the IP manually.
      My Computer
    Quote Quote

 

  Related Discussions
Hi all, i need your advise pls. I have a Samsung series 7 laptop with 2 usb3 ports and 2 usb 2.0 ports. On the device manager i can see the installed driver Intel usb 3.0 root hub and intel usb 3.0 extensive host controller. I also have purchased a Samsung 64GB sdxc card SDXC UHS...
I have a HP dv6910us Pavilion and the DVD is not listed in Device Manager. DVD Tray opens and light comes on but does not play DVD. 1st USB port on left side gets - USB Device Not Recognized.One under it works and one on the right side works. OS Windows7 Ultimate. It is running kind of screwy so...
HI I have searched high and low for a resolution. OK. When I went to add a new Bluetooth keyboard (Control Panel>Add Devices). When pressing Add Device, nothing happens. I have two Bluetooth devices already installed, are listed under "Devices" are "found" and work fine.
Device connect/failed to connect
in Hardware & Devices

Every few minutes, I get a fraction of a second delay while some device in the system tries to connect and then another second when I get the failed to connect. I set up the sounds so that I know that it is the device connect and failed to connect. Is there some way I can identify the device that...
Hi guys, so I did some tweaking around in Sounds and Realtek HD Audio Manager, and I finally got stereo mix working. There's only one catch. It only picks it up if my default device is Reaktek HD Speakers. I tried setting my USB headset as the default device, since I never use my monitor's built in...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 15:19.
Find Us