Perpetual Reboot for Failed Win 7 Upgrades from vista

    Perpetual Reboot for Failed Win 7 Upgrades from vista


    Posted: 12 Aug 2009
    In certain scenarios, a failed Windows Vista upgrade to Windows 7 can throw the computer into a perpetual cycle of restarts, Microsoft informed. The Redmond company did not offer specific details on the causes of a Vista to Windows 7 upgrade failure, but it did offer a workaround for end users affected by this specific issue to put a stop to the continual reboots. The KB article Microsoft supplied for this issue was published after the RTM of Windows 7, and it indicates that the problem impacts all editions of Vista RTM, SP1 and SP2.


    “When attempting to upgrade from Windows Vista to Windows 7 the upgrade attempt may fail with the message “This version of Windows could not be installed, Your previous version of Windows has been restored, and you can continue to use it." However, the next reboot of the machine will launch the upgrade process again only to fail with the same message,” the software giant informed.
    Read More -->
    septprince's Avatar Posted By: septprince
    12 Aug 2009



  1. Posts : 8,375
    W7 Ultimate x64/W10 Pro x64/W11 Pro Triple Boot - Main PC W7 Remote PC Micro ATX W7 Pro x64/W11 Pro
       #1

    More then likely a great deal of that will tend to be seen on premade systems rather then on custom builds where most would automatically plan a clean install of 7 from the start. It's still a good one to post here!
      My Computers


  2. Posts : 202
    Windows 8 Pro 64 bit
       #2

    so is this for people trying to upgrade to windows 7 from vista? So i take it its ok if you have allready upgraded.
      My Computer


  3. Posts : 1,112
    XP_Pro, W7_7201, W7RC.vhd, SciLinux5.3, Fedora12, Fedora9_2x, OpenSolaris_09-06
       #3

    Fortunately, it only happens "In certain scenarios"...

    The more I read the link, the 'stranger' it becomes...
    Perhaps because its written in "Springlish"?

    “Windows Vista will have been restored on the computer but the Boot Configuration Database (BCD) store has not edited to restore Windows Vista as the default booting operating system,” Microsoft stated. “The computer will continue to boot to the Windows 7 Setup and then fail until the BCD database has been restored to its previous state.”
    AFAIK, BCD store is not an executable, and cannot edit nutthin.
    MS calling it a 'database' tends to affirm my limited knowledge.

    The solution is: Vista, executing the Vista command:
    X:\boot\Bootsect.exe /NT60 All
    which is, generally speaking, one of the Win 7 'cure-alls':
    Writes the: (in Win7_words: Vista or later) boot sector, blah-blah...

    So, TMALSS, V_Bootsec.exe is modifying the file 'bcd' database differently from the Win_7 mods, which are obviously NG.

    Anybody know the specific differences?
    Is the 'GUID' the culprit?
    "Inquiring minds would like to know", and metoo.
      My Computer


  4. Posts : 8,375
    W7 Ultimate x64/W10 Pro x64/W11 Pro Triple Boot - Main PC W7 Remote PC Micro ATX W7 Pro x64/W11 Pro
       #4

    Under certain circumstances usually temporary from the start until MS fixes a problem with any new service pack out some have run into problems installing SP2 or 3 on XP as well as the two SPs for Vista. Without any hardware faults most often a failed upgrade generally proves itself to be a user error in most cases however.
      My Computers


  5. Posts : 1,112
    XP_Pro, W7_7201, W7RC.vhd, SciLinux5.3, Fedora12, Fedora9_2x, OpenSolaris_09-06
       #5

    This one is no user error - its a flat-out "Bug"...
      My Computer


  6. Posts : 3,322
    Windows 8.1 Pro x64
       #6

    I got the same problem when I tried using an upgrade disk to upgrade from XP to Vista.
      My Computer


  7. Posts : 8,375
    W7 Ultimate x64/W10 Pro x64/W11 Pro Triple Boot - Main PC W7 Remote PC Micro ATX W7 Pro x64/W11 Pro
       #7

    Everlong18 said:
    I got the same problem when I tried using an upgrade disk to upgrade from XP to Vista.
    That would simply point out a more commonly seen problem when going to upgrade from one version to the next without it being tied to one version alone namely Vista or 7. I can imagine similar if not the same was seen when upgrading from 2000 to XP at times.
      My Computers


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 17:24.
Find Us