ATTENTION Crucial M4 SSD owners

Mine may not have been working since last May when I installed the SSD.

The only reason I tried "fixing" it is for MJF's benefit and future reference.

I have no use for it myself.
If I did I might have noticed it was broken the past 8 months.

I checked mine and it is indeed running. The start time is about 24 hours after installing Win 7 on the SSD as a clean install

It shows Soluto stopped working due to faulting module cpuidsdk64.

Mike's system is quirky.

Mine works too, and is working after updating the firmware.

Britton30 said:

I checked mine and it is indeed running. The start time is about 24 hours after installing Win 7 on the SSD as a clean install

It shows Soluto stopped working due to faulting module cpuidsdk64.

Mike's system is quirky.

Why thank you Mr. President of the Quirky club.

Well I'm not sure of the reason why but I found a probable solution for mine.
Will post when it updates.

I hope it works for MJF.

Mike

Thanks for checking on the Reliability Monitor.
I went and did the OS transfer manually aligning the partitions (sys res, C: ) using Macrium. Reliability Monitor appears to work fine so the Paragon Migrate software may be the issue. I checked the RAC agent settings etc. Maybe Paragon deliberately gets rid of it???????????

Edit: Clearly not an issue for most. IF Paragon responds to the issue I'll provide feedback - Thanks for yours Hopalong X.

Britton30 said:

John, with a new install you will need to download and install LAN (NIC), graphics, and maybe SATA3 drivers, they are all stored on the OS drive.
go to the manufacturers' site, don't trust Windows updates, but let then all install before getting new drivers.:)

Thanks Gary I have the LAN (from Gigabyte and the rev done but not the other drivers you mention will do that now :)

Am up and running at ast none of the site downloads worked so as a try I reran my Gigabyte board disk and bingo here we are in SSD mode! Boy is it so much quicker except for the UAC to to desktop. But a minor hitch.

Now for my nemesis WLM I don't know what it is but it drives me mad every time I doa setup - use thesame ID and pw but it hasa mind of its' own.

Good to hear that John, you will like the SSDs speed. for WLM, try a post here: Browsers & Mail - Windows 7 Forums

mjf said:

Thanks for checking on the Reliability Monitor.
I went and did the OS transfer manually aligning the partitions (sys res, C: ) using Macrium. Reliability Monitor appears to work fine so the Paragon Migrate software may be the issue. I checked the RAC agent settings etc. Maybe Paragon deliberately gets rid of it???????????

Edit: Clearly not an issue for most. IF Paragon responds to the issue I'll provide feedback - Thanks for yours Hopalong X.

Paragon claim to have never heard of the problem.
My specs look quite normal so I will try again. I'll report back the results.
Update:
Trashcan for the Paragon Migrate. A little more effort using readily available free tools and it works.

Been helping another member with an M4 in C&Dbg, and used this thread for reference.

I looked through, and didn't notice that this was posted:
M4 firmware 0309 is now available - Crucial Community