 | |
| |
| 14 Jan 2012 | #1 |
| | New ram installed, cant get voltage/frequency to stick. Hi, i've just installed 8GB OCZ Gold DDR2 RAM on my Asus P5Q Pro Turbo board, the timings on the RAM state PC8500 1066Mhz 5-5-6@2.10v. I have checked in the BIOS and the frequency was set to auto and the voltage was also set to auto, I have set these to 1066 and 2.10 respectively but when I checked with CPU-Z it reports frequency 534.9 and voltage 1.80. I made sure I saved the changes before i exited the bios. Any thoughts or input would be appreciated. Thanks. |
My System Specs | |
| 14 Jan 2012 | #2 |
| | Don't forget that the first D in DDR stands for double. Also CPUz always shows the actual bus speed, which in your case would be 533 for 1066 ram, and yours is slightly higher at 534.9. |
| My System Specs |
| 14 Jan 2012 | #3 |
| | Thanks stormy, so the figures im seeing are correct? is it right that it is running at 1.80v rather than the specified 2.10? Thanks, |
| My System Specs |
| . |
| |
| 14 Jan 2012 | #4 |
| | Check ur power options in control panel and make sure you are set on High Performance.... |
| My System Specs |
| 14 Jan 2012 | #5 |
| | Is it not the bios that controls the voltage supplied to the ram slots? |
| My System Specs |
 |
New ram installed, cant get voltage/frequency to stick. problems?
| Thread Tools | |
| Similar help and support threads for: New ram installed, cant get voltage/frequency to stick. | ||||
| Thread | Forum | |||
| Windows 7 installation from USB stick now USB stick not working?! | Installation & Setup | |||
 How create bootable USB stick/hard drive without floppy installed | Hardware & Devices | |||
| CPU Voltage & CPU VDDA Voltage | Overclocking and Case Mods | |||
| RAM Voltage | Hardware & Devices | |||
| usb stick was not installed succesfully | Hardware & Devices | |||
All times are GMT -5. The time now is 12:49 AM.
