Windows 7: Show Us Your Rig [4]

linnemeyerhere · 28 Sep 2012

+1 on the 3 screens, wow didn't notice the tri 27" set up, now that's a wall of monitors !

Britton30 · 28 Sep 2012

Quote: Originally Posted by linnemeyerhere

Tanya,
Don't sweat the PSU position I like you installed my PSU upside down for the very reason of added case air flow and everything is in nice order.
Attachment 234044

But that pulls all the heated air from the case through the PSU which may cause it to overheat in some scenarios.

linnemeyerhere · 28 Sep 2012

You could be on to something Britton but the more I've read and having now done this the temps in my case have never been lower and though I can't monitor the PSU speeds or temps like I said all seems to be normal and I'll advise if I notice added noise or fan speeds and heat during intense computing or gaming.

linnemeyerhere · 28 Sep 2012

Shot some pictures of the oft ignored wiring side of my case just because I could.

Britton30 · 28 Sep 2012

Alan, that's about as good as it gets on the wiring side. I especially like your SSD mounting solution.

You know with most cases, the PSU fan draws air from inside the case, eh? I notice all of your visible fans are exhaust.

linnemeyerhere · 28 Sep 2012

Britton,
Yes, except for the 140mm next to the PSU and then the two 120mm in the side and front one blows across the HDD's and out the rear then the other draws air in from the front down low and is unobstructed by any cages or other.

Wordsworth · 28 Sep 2012

Well, since linnemeyerhere bared the oft ignored wiring side thought I'd do the same; maybe we need a "Show us your oft ignored wiring side" thread.

Not the nice side for sure.

linnemeyerhere · 28 Sep 2012

I strongly suggest not placing a SSD in a drive rack and just use Velcro dots to affix it to the floor or case back, clean out of the way and easy.

Wordsworth,
Very clean wiring job and I like the foam taped anchors for the routing, plus the LL wheelies........sweet!

Wordsworth · 28 Sep 2012

The wiring is as good as I could do on this side anyway in this build. In a rebuild I'll cut out some more access holes in the mobo tray as it came stock with only two and at least one more would have made a difference in how clean even the backside looked.

The anchors are actually hard plastic but had I seen foam anchors I probably would have bought those as when I bought these I feared the side cover might not have room to close and the foam would have a little give where these don't. All worked out though after all as it's only the thick wires in back that make closing the side cover slightly difficult.

Why exactly do you not recommend putting an SSD in a drive rack? I could understand if someone simply laid it in a 3.5 bay but this box has a 2.5 bracket for the SSD. Just wondering if there's some other reason.

linnemeyerhere · 28 Sep 2012

No other reason other than unless you want to look at the drive if that's even an option then place it out of the way so that those drive bays can hold spinners and the fans can cool the heat off them. SSD's as you know generate minimal heat and can be place almost anywhere.

Windows 7: Show Us Your Rig [4]

Show Us Your Rig [4] problems?