Post Your Overclock! [2]

Impressive if it works for you i would leave it but also 1.48 seems kinda high but if it is solid leave it

and enjoy the fruits of your labor

Nice1 Bungee, You're a braver man than me, Fairplay though you got a nice oc

llc has come in right handy although my board defaults llc to it's highest level so had to change that. I've not tried to oc my cpu without any llc but i reckon it would take a lot more patients than i have

Britton30 said:

What a smart man (essenbe) told me is that he uses the ASUS AI suite to set some overclocks until he gets BSOD, then goes into BIOS and sets it to just below what caused it.

Gary, all I use it for is to adjust voltage in AI Suite. I set it up in bios, but when stress testing I use AI to adjust voltages. When I find the right one, I go to bios and change it there. AI allows you to change it in windows, but does not change bios. You have to do that. I never use it for anything else other than monitoring.

essenbe said:

I never use it for anything else other than monitoring.

Do you get many false readings with AI suite? When i had Ai suite II installed i found it gave quite a few false readings for fan speeds and northbridge voltages among other things.
Is it the newer version III for your board?
It could be a really good monitoring software once all the little bugs are sorted enit.

Dropping to 4.4 for 24/7 use. 4.5 and beyond idles at too high a vcore (1.48 or more).
Cinebench only drops from around 7.85 to 7.44. I can live with that...
I can see a Sabertooth in my near future!
Thanks for your comments and advice guys.
Cheers,
J

ganjiry said:

essenbe said:

I never use it for anything else other than monitoring.

Do you get many false readings with AI suite? When i had Ai suite II installed i found it gave quite a few false readings for fan speeds and northbridge voltages among other things.
Is it the newer version III for your board?
It could be a really good monitoring software once all the little bugs are sorted enit.

To me it is dead on i use HW monitor and readings in the Bios to compare so far so good they been dead on

Nice 1, They must have worked some of the bugs out enit.
I may give it a try again as i liked the probe part of it aswell as the fan control.

Bungee18 said:

Dropping to 4.4 for 24/7 use. 4.5 and beyond idles at too high a vcore (1.48 or more).
Cinebench only drops from around 7.85 to 7.44. I can live with that...
I can see a Sabertooth in my near future!
Thanks for your comments and advice guys.
Cheers,
J

your cinebench would be higher if you use the FSB @4.7 im hitting 8.10

Progress update.
I don't usually have much patience when it comes to overclocking but its stopping me thinking about hospital by keeping my mind busy
I've been testing different voltage's @ 4.4Ghz but got a stable 4.4Ghz, 200x 22, @1.428v, Drops to 1.416 @ load.
cpu/nb 2400 @ 1.237v
HT Link 2000 auto v
cpu and cpu/nb llc set to high.
Memory still stock xmp.
Everything seemed stable untill it bsod while playing War Thunder.
So i upped the cpu/ nb to 1.25v which improved stability aswell as increasing score's in everything i've tried so far.
10 Passes IBT in 428.00, Max temp was 47c but settled @ 45c.

Good job tommy and Ryan. you're going to make those AMDs squeal and say "Bob's your uncle".