Show Us Your Rig [3]

Punkster said:

Hello, Forum!

A few days ago I did a clean Windows 7 install so I took a little apart my PC

Then re-did the wiring and came out pretty tight! I strongly believe this is my best wiring to date

Of course, I was hungry after that so I made a little snack Double Ham/Cheese Burger with all the toys needed to satisfy my deadly appetite

Cheers

P.

I think that's the best wiring job I've seen to date. Certainly blows my last custom build away. Nice Job!

Not the "latest or greatest" but here it is

Thanks a whole lot for the kudos. I think that the board is holding me back a bit on the OC, but could be the chip as well. I was tryin for 4.4, but no go. I will be upgrading the mobo and GPU when I have the $$$$, it will stay as is for now. It does, however, blow through EVERYTHING I throw at it with flyin colors.
It took almost an hour to do the wiring right. I am pleased with the end results.

linnemeyerhere said:

gldndragn welcome to SF,
4.4 is very aggressive and likely it's the H60 holding that back as well. Voltage, voltage, voltage.....heat...heat and more heat. I miss my 965 really is some ways but as my board was FX ready it was always a next phase to a low cost 8 core and it's clocking to 4.7 when weather permits.

I dont recall that my h60 wasnt cooling it well, but it wont load into windows without restarting right as my desktop loads. No bsod, no freeze....just an instant reboot. Mayhaps I need a little more cpu v.
I will give that a shot.

gldndragn said:

Not the "latest or greatest" but here it is

I have the H60 cooler as well. Did you see a big difference with the second fan?
I was thinking about doing a push/pull setup. Right now it just has the stock fan pulling air away out the back.

chromatica said:

gldndragn said:

Not the "latest or greatest" but here it is

I have the H60 cooler as well. Did you see a big difference with the second fan?
I was thinking about doing a push/pull setup. Right now it just has the stock fan pulling air away out the back.

Yes I did, I upgraded to two cooljag everflaw 120 mm fans. Needed to get a pwm fan splitter to run both off of the cpu fan header on my mobo. It took load temps from around 55c down to around 45c-48c