New
#1021
Hey guys, I saw this on gizmodo so i thought I would post it...
What do you think?
Not soon enough for me to have an opinion yet....
Troy.
Show Us Your Rig [4]
-
-
New #1022
fan needs painted another color
-
-
New #1024
That color scheme reminds me of Tony the Tiger xD
Last edited by moneybagman; 11 Jan 2013 at 20:21.
-
-
New #1026
the psu at the front needs to be painted as the theme of this box.
otherwise this case is ok in my opinion. i like the fact that the whole case is see through. but all this bars around it make it look like it could withstand a car crash.
-
-
-
New #1029
First Build
I finally finished modding the case for my first computer build. I chose the Antec Two Hundred V2 for its size (I don't have much room), HDD capacity (six), the 2.5" hot swap bay (I added a 3.5" bay), air filtration, and the relative ease of sealing up most of the air leaks to reduce dust collection (my neck of AZ is seriously dusty). This is what it looked like before I went after it:
The covered slot below the three 5.25" bays is the 2.5" hot swap bay.
This shot shows the filter in the front panel.
The plastic panel that is swung out below is for mounting two 120mm fans.
I don't know how many pictures I can put in a post so I'm going to start a new one.
-
New #1030
First Build, Part Two
These are shots of the case after I worked on it. I worked on top of my washing machine because it's much easier on my old back.
Not much change here. I got an el cheapo DVD drive (on sale, of course) to help with making the PSU cables. I'll use the drive to install Win 7, then replace with a BD drive once the rig is up and running.
This is the back side (duh). In the past, I used a product called Sand Ban to degrease and degloss paint before painting. I couldn't find it so I used another product that made the same claims. The *&^%$#@!s lied . The paint chips pretty easily in places but, since little of it shows (and it's been too cold to repaint), I'll just touch up the chips when they happen with a felt pen.
Here is what the case looks like with the right side panel removed. I added a large grommet to cover the big hole by the PSU, cut holes for the four smaller grommets near the bottom, and used two of the smaller grommets and a filler to cover the slot near the top. The front panel wiring runs inside the large, flat sleeve running down the middle. I haven't pulled some of the cables out and through the grommets yet but there is enough slack to do so once the MOBO in place. You can see a glimpse of the sound deadening foam added to the side panels (it's also on the top and back).
The next two shots show how the two large PSU cables (one home-brewed) are anchored in the so called cable management area (Antec's term).
This shot shows both the sound deadening foam on the left side panel and the fan there. there are four fans altogether: two in front blowing air in over the HDDs, one on the left panel pulling air in through a filter, and one exhaust fan on the back (I used a filter housing to block the blowhole; I can always add a fan there later if I should ever need it). The fans are ThermalTake AF0018s with an attached speed control pot. Besides having their own speed controllers, these fans are quieter than the two 2 speed Antec fans that came with the case.
Part Three coming up shortly.
Related Discussions