Official Seven Forums Overclock Leader boards
-
Yes Ryan, I think I'll leave them alone.
Maybe.
I don't blame you mate 
-
-
No, only the pic I posted earlier after the lapping was done. The TIM was a light tan chalky substance that rubbed off with my finger tip. The die is about 5/16th" wide and maybe 7/8th" long and very thin, maybe less than 1mm
-
If you just slap some quality paste on it then put it in the pc, it would run much cooler, when I build my daughter`s new rig I`ll do it to my 3570k and see how it does.
It`s a shame you nicked it 
-
-
I think what I did wrong was trying to use the corner of the blade to get under the IHS on the first corner. You should use the center of the blade's edge and rock it back and forth.
-
I think what I did wrong was trying to use the corner of the blade to get under the IHS on the first corner. You should use the center of the blade's edge and rock it back and forth.
That sounds pretty likely and easily done chap...Have a couple of beers and forget it instead of kicking yourself though 
-
I think what I did wrong was trying to use the corner of the blade to get under the IHS on the first corner. You should use the center of the blade's edge and rock it back and forth.
That sounds pretty likely and easily done chap...Have a couple of beers and forget it instead of kicking yourself though
Good advice there, I will have a beer too to give the old gal the send off she deserves.
-
-
I think what I did wrong was trying to use the corner of the blade to get under the IHS on the first corner. You should use the center of the blade's edge and rock it back and forth.
That sounds pretty likely and easily done chap...Have a couple of beers and forget it instead of kicking yourself though
Good advice there, I will have a beer too to give the old gal the send off she deserves.
I'll smoke a fat one on your behalf Gary 
-
I think what I did wrong was trying to use the corner of the blade to get under the IHS on the first corner. You should use the center of the blade's edge and rock it back and forth.
That sounds pretty likely and easily done chap...Have a couple of beers and forget it instead of kicking yourself though
Good advice there, I will have a beer too to give the old gal the send off she deserves.
Ditto Drink up
-
Thanks Larry. Moe, and Curly.
-
Yep, just relax...
Nobody at least told, you were a hero deserving a medal for having save the whole world with your money lost on that chip!
