New
#1
Noisy Fan
alright so i cleaned out the dust from my computer and installed speedfan which froze my computer but i eventually got it working and it shows core 0 at around mid 50c with a flame symbol core 1 alternates between a check mark an arrow and a flame as does core 2 and 3 and te last three are at a low 50C. my computer is elevated and this started after i updated the Bus controller with slimdriver and my AMD graphics. i've updated teh BIOS done a clean boot and talked to the guys at dell support who said it was a software issue and got mad because i had updated 7 home premium with ultimate an said that that had messed up the command center which regulated the fans yet the computer ran fine with ultimate and i doubt that 7 ultimate was that different from home premium to make a programme ment to run on premium not work so i went to software support and claimed that nothing was wrong with the software so putting my trust with you guys since you haven't let me down so far any suggestions? oh i switched the cpu to passive instead of active. oh and in the BIOS under preformance there is an option to enable turbo mode yet despite trying both disabled and enabled does nothing the line above remains turbo enabled and the driver on the dell support for turbo can't install because it lacks the hardware so thats my story. :)