Show Us Your WEI [4]

xplode said:

Usually it's 7.7 because of the CPU (i7-3820) but now i overclocked it to 4.3GHz and ganed 0.1 aditional score.

Nice scores xplode, I think you need to update your system specs :)

xplode said:

Sorry I forgot about them. They're from my very old system. This one I bought 2 months ago.

Good stuff, that's a nice rig you have there

essenbe said:

I don't believe so. Your graphics drivers are going to load anyway. I have everything disabled in startup except my Anti Virus. I'm not sure what some of those Asus programs in startup are, but most of the asus utilities are resource hogs. I used to have them, but last reinstall, I didn't install them.

Before the score was higher, with Asus utilites also.

Britton30 said:

Boshko it may be due to a driver update if you've done one?

I was thinking about that. I have updated it before few days...

Great scores xplode!

Why is the SSD score so low ?

COMPUTIAC said:

Why is the SSD score so low ?

Did you run it while maybe a virus scan or something was going? I would reboot an run it again, sure it will go up.

Dude said:

COMPUTIAC said:

Why is the SSD score so low ?

Did you run it while maybe a virus scan or something was going? I would reboot an run it again, sure it will go up.

Could need a Firmware update i'll be looking for another one sooner or later

I thought I was doing good by buying OCZ Agility 3 but there are screwed up can't firmware update unless you have another drive in place I know I could use a USB stick to boot but that is just too much drama for me also probably get something bigger like a 256GB anyway

No, same score, no change.

I had nothing running the first run, just a few tabs open. This run, nothing was open.
I had the same score on 5.31 also.

COMPUTIAC said:

No, same score, no change.

I had nothing running the first run, just a few tabs open. This run, nothing was open.
I had the same score on 5.31 also.

Thats strange, reseat your ssd cables, unhook your other hdd and try again. It sounds like it's looking at your spinner as the primary.