Windows 7 x64 8gb RAM still running Dayz @ 10 FPS

Page 2 of 2 FirstFirst 12

  1. Posts : 9
    Windows 7 Ultimate x64
       #11

    Is the CPU fan turning?

    Are the fins under the CPU fan clogged with dust?

    I am a 57 year old gamer and I have never lost a CPU or Graphics Card due to overheating and I have never owned a liquid cooled device.

    I do clean my CPU and Graphics Card regularly.
      My Computer


  2. Posts : 1,007
    Winndows 7 32 bit
       #12

    TheSpirtOfRadio said:
    yea that was exactly my problem.... i raised it back to 3.4GHz and it ran @ 50-60 FPS but now i need a liquid cooled CPU because it overheated pretty quick
    Hi TheSpirtOfRadio,

    Its good to know that is working fine once processor is set to run at optimum speed. You should purchase a good heat-sink and fan assembly it should not be necessarily the liquid cooling assembly only.

    Keep us posted with the results so we can advise you further.
      My Computer


  3. Posts : 7
    Windows 7 Professional x64
       #13

    I would re-seat the heat sink with fresh thermal paste. Is this a stock heat sink fan? It would take a very poor flowing case and a heatsink caked full of dust to make it over heat when running at stock clocks, even on the stock HSF.

    Use an air compressor if available, don't waste your money on canned air.
      My Computer


  4. Posts : 9
    Windows 7 Ultimate x64
       #14

    livevil904 said:
    I would re-seat the heat sink with fresh thermal paste. Is this a stock heat sink fan? It would take a very poor flowing case and a heatsink caked full of dust to make it over heat when running at stock clocks, even on the stock HSF.

    Use an air compressor if available, don't waste your money on canned air.
    Canned air is not a waste of money. Compressed air from your standard home air compressor can contain many unwanted things, the worst of which is water, dirt and oil and should not be sprayed into the inner workings of your computer for obvious reasons. Canned air is clean and dry and the little plastic tube affords exact placement of the airflow right where you need it.
      My Computer


  5. Posts : 6,741
    W7 Pro x64 SP1 | W10 Pro IP x64 | W8.1 Pro x64 VM | Linux Mint VM
       #15

    Devlin1888 said:
    Could always hoover your computer, always gives a help with temps!
    If ever there's advice not to follow this is it. Never vaccuum a PC, the elctro-static discharge from a vaccuum has the potential to kill any/all of the components in a PC. Use compressed air in short, sharp bursts while holding fan fins still so as not to damage the bearings.

    NEVER use a vaccuum.
      My Computer


  6. Posts : 7
    Windows 7 Professional x64
       #16

    ACraigo said:
    livevil904 said:
    I would re-seat the heat sink with fresh thermal paste. Is this a stock heat sink fan? It would take a very poor flowing case and a heatsink caked full of dust to make it over heat when running at stock clocks, even on the stock HSF.

    Use an air compressor if available, don't waste your money on canned air.
    Canned air is not a waste of money. Compressed air from your standard home air compressor can contain many unwanted things, the worst of which is water, dirt and oil and should not be sprayed into the inner workings of your computer for obvious reasons. Canned air is clean and dry and the little plastic tube affords exact placement of the airflow right where you need it.
    I've always used an air compressor. Never noticed any water, dirt, or oil come out. Any amount that is not noticeable is not going to harm a computer. The only legitimate criticism of air compressors that I've heard is that they can be too high of pressure, but that is remedied by simply airing it down to about 30 psi and leaving it off.. as well as general common sense.
      My Computer


  7. Posts : 7
    Windows 7 Professional x64
       #17

    Boozad said:
    Devlin1888 said:
    Could always hoover your computer, always gives a help with temps!
    If ever there's advice not to follow this is it. Never vaccuum a PC, the elctro-static discharge from a vaccuum has the potential to kill any/all of the components in a PC. Use compressed air in short, sharp bursts while holding fan fins still so as not to damage the bearings.

    NEVER use a vaccuum.
    I've always heard this, but i've also heard many many people say that they've vacuumed their computer for years with no issues, one guy said he has a computer repair shop and uses an ordinary computer to clean out hundreds of computers, not one having an issue.

    I would imagine if you had the computer grounded to the wall (plugged in) that any static discharge would be drawn to the chassis of the computer and go strait to the ground, leaving nothing harmed. Regardless, I only use a vacuum to clean my fan's dust filters and make sure to keep a good distance from the motherboard. Better safe than sorry.
      My Computer


 
Page 2 of 2 FirstFirst 12

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 19:47.
Find Us