scannow finds faults

Did you run SFC /SCANNOW several times? It's quite common it finds more errors than it can repair in a single pass, needing a reboot and another scan. Usually two to three passes is enough, I remember couple of times done it four or five times.

This quote from our SFC /SCANNOW tutorial:

   Note

• If SFC could not fix something, then run the command again to see if it may be able to the next time. Sometimes it may take running the sfc /scannow command 3 or more times to completely fix everything that it's able to.
• If not, then download and run the 32-bit (x86) or 64-bit (x64) System Update Readiness Tool for your same installed 32-bit or 64-bit Windows 7, restart the PC afterwards, and try the sfc /scannow command again.
• If still not, then try using OPTION ONE above to run the sfc /scannow command at boot.
• If still not, then you can attempt to run a System Restore using a restore point dated before the bad file occured to fix it. You may need to repeat doing a System Restore until you find a older restore point that may work.
• If still not, then you can use the steps in the TIP box in the OPTION THREE section below to manually replace the files that SFC could not fix if there are not to many fix.
• If there are to many files to manually fix, or you prefer not to use OPTION THREE below, then you could do a repair install without losing anything.

Kari

Good to know things are OK.

About the SFF /SCANNOW, this post gives some more information to help understand it: Problem with repair install - error msg disk version not comp with OS