I have Windows 7 Ultimate x64 installed on my self built PC. A month ago I did a clean reinstall due to BSOD's since then no more BSOD's but the reliability monitor stopped working on the 22.04.15, and I can't find out how to get it going again I have gone through all the systems settings and admin tools but no joy. Can anybody tell me how PLEASE:) Error reporting is on etc.
Hello Lenn, and welcome to Seven Forums.
You might see if resetting Reliability Monitor may help to get it working again. :)
Reliability Monitor - Reset
Sorry Brink IT DID IN FACT FIX IT all seems fine I will just to wait until to Tomorrow to see if it collects data. Thank you very much......lennmann
So far it is still blank but the notice says that it will take a while til enough data is gathered to rate the performance. It is still less than 24 hours since I reset it,but I will keep you posted as to how it goes....Best Regards....LENNMANN
Hi brink,
Still no joy with reliability monitor I have gone through Admin Tools-Services and checked all that I could find to do with performance or error monitoring are started and started those that were not. Altered one to do with fault monitoring from manual to automatic so far nix.
best regards..Len Mann
I'm sorry to hear that. It will then usually take a repair install or clean install to fix it.
Hi Brink, I'm sorry too as I only did clean install about a month ago because of too many BSODs. The clean install took care of them almost completely except the Elton USB3 driver with my motherboard was old and windows didn't like it. But Windows update fixed that so after a reg clean then a sfc scan all seemed ok until reliability monitor stopped working. Its a b...... a clean Windows install is quick and easy but its all the other programs that have to be re installed and reactivated that takes a lot of time but thank you for your help it could and should have worked.
All the Very Best LenM... PS I will try the repair install first and hope works
Hi Brink, did a repair install and it still did not work but I found out you must turn on reliability monitor before it will work after a reset or repair install. From Control Panal-Adim Tools-Task Scheduler-Microsoft-RAC- and enable RACTask as it will be left as disabled after a reset et al then hope like hell it works, but confidence never hurts. In any case I wont give up till I get the Bas....... of a thing going. I WILL LET YOU KNOW IF DOES WORK IT MAY help others
ALL the Very Best......LenM
Quote