Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Windows tries to perform chkdsk on every boot but fails

01 Jun 2015   #1
fireillusion

Windows 7 Ultimate x64
 
 
Windows tries to perform chkdsk on every boot but fails

Hello everyone.
Today my computer froze upon exiting Battlefield 3 and had to shut it down manually.
After a lot of problem solving (I had to change the hdd port on the m/b) I am left with the problem displayed in the attached image and cannot figure out what to do. I have searched around and tried a lot of repairs but nothing happens. I also run sfc / scannow command several times (in safe mode also) which finds some problems that cannot be fixed.
Any help would be appreciated.
The ultimate solution would be to format my ssd and hdd




Attached Thumbnails
Windows tries to perform chkdsk on every boot but fails-img_20150601_203931.jpg  
My System SpecsSystem Spec
.
01 Jun 2015   #2
RolandJS

Windows 7 Professional 64-bit
 
 

Report back what happens when you attempt to F8 boot into Safe Mode.
My System SpecsSystem Spec
01 Jun 2015   #3
fireillusion

Windows 7 Ultimate x64
 
 

It boots in safe mode. Nothing out of the ordinary happens.
I have to mention that the computer boots normally to windows after the attached message goes away.
My System SpecsSystem Spec
.

01 Jun 2015   #4
Boozad

W7 Pro x64 SP1 | W10 Pro IP x64 | W8.1 Pro x64 VM | Linux Mint VM
 
 

What disk is it trying to check? Open an elevated command prompt and type in fsutil dirty query c: (change the driver letter as required for each driver you have).
My System SpecsSystem Spec
01 Jun 2015   #5
fireillusion

Windows 7 Ultimate x64
 
 

Quote   Quote: Originally Posted by Boozad View Post
What disk is it trying to check? Open an elevated command prompt and type in fsutil dirty query c: (change the driver letter as required for each driver you have).
Just run the command you suggest on my two drives and reports that both are NOT dirty
My System SpecsSystem Spec
01 Jun 2015   #6
Boozad

W7 Pro x64 SP1 | W10 Pro IP x64 | W8.1 Pro x64 VM | Linux Mint VM
 
 

Run chkdsk on the non-system drive via command prompt. Disk Check
My System SpecsSystem Spec
01 Jun 2015   #7
fireillusion

Windows 7 Ultimate x64
 
 

Quote   Quote: Originally Posted by Boozad View Post
Run chkdsk on the non-system drive via command prompt. Disk Check
just did. It force dismounted the drive, performed the check and found no problems.
I just did sth else. I found in task scheduler the entry about autochk and deleted it. I will reboot now and report back.
I found an article in ms kb about it but I don't know if I will fix the problem or simply hide it.

Edit:
Just tried this https://support.microsoft.com/en-us/kb/831426 but still no luck. It tries to perform the check at evey boot
My System SpecsSystem Spec
01 Jun 2015   #8
RolandJS

Windows 7 Professional 64-bit
 
 

I found the following Microsoft link, you may not like the answer found in here:
"http://microsoft.com/en-us/windows/forum/windows_7-windows_programs/"
"how-to-disable-the-chkdsk-check-disk-on-start-up/35f58c69-7a6c-4e1b-aec3-26d7131ec643"
For some reason, link does not display properly, copy and paste both pieces into your browser address field, then remove my quotation marks, and remove the space between programs/ and how-to-disable
--- that link works in my FF, but won't correctly post in here.
My System SpecsSystem Spec
02 Jun 2015   #9
fireillusion

Windows 7 Ultimate x64
 
 

I will try this, this afternoon.
My main concern is the volume drive it tries to check. What drive is this? Could it be the system reserve disk?
I recently installed an ssd but for some reason the system reserve partition was installed on my secondary mechanical drive. I think it had to do with "F6" drivers....
My System SpecsSystem Spec
02 Jun 2015   #10
GokAy

Windows 7 Ultimate x64 SP1
 
 

It happens when you install Windows without removing the old HDD. It can be fixed with EasyBCD.
----------

I wonder if your other HDD is failing. Can you remove it and see if the error change?

Maybe you can use:

Partition Wizard free bootable media to mark the Win7 partition(SSD) Active, then run Startup Repair - Run up to 3 Separate Times.

Wait for experienced members to give a green light on this one though.
My System SpecsSystem Spec
Reply

 Windows tries to perform chkdsk on every boot but fails




Thread Tools Search this Thread
Search this Thread:

Advanced Search




Similar help and support threads
Thread Forum
SFC /SCANNOW fails, also will not perform an in place upgrade..
PC was brought to me because it wouldn't run windows updates, windows quit installaing them about 3 mos ago. Tried the system file checker reports bad files but was unable to repair them, then after going round and round with that i said f it and tried a repair install, at 15% it tells me that...
Performance & Maintenance
Windows fails to boot, startup repair fails to fix
Hello more knowledgeable person than myself. I've been having trouble trying to get my computer to boot; I'd noticed a drop in performance (still unsure why) so decided to boot up in safe mode and poke around - it was not my original intention to install Advanced SystemCare 5.3.0 but somehow it...
General Discussion
HDD: chkdsk /r fails at same point each time
someone more knowledgeable than I may know the 'rest of the story': I am working on a little WD "My Passport" usb ext drive which works, except it seems to 'hang' sometimes when put to use, or runs very slowly as measured by 7's little time-estimator and kb/s or mb/s meter. When I run WD's own...
Hardware & Devices
Creating System Image Fails every time - Run CHKDSK /R
Hi All I want to create a system image on my NTFS formatted portable WesternD HDD. Now It has about 250GB of space left(the portable HDD), and the Laptop PC that i want to create the image of, tells me I need about 199GB for the system image. Then first time I created the image, it gave me a...
Backup and Restore
Cannot Perform ChkDsk
Hi there! I am new to the forum and could really use some advice. I hope this is the right forum to post in! I have never run into this problem before and I am pretty computer savvy usually. I have an external hard drive that is a Western Digital 1 TB. Now the problem I have is that when I plug...
Hardware & Devices
ChkDsk fails completely - PLEASE HELP
I've spent many many many hours trying to find out what is the problem, so let me explain to you what I've gone through. First encounter: I scheduled a chkdsk C:/r for next reboot, sweet right? Go to sleep and wake up, boot up the PC and go take a shower only to come back to reveal some awful...
Performance & Maintenance


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 12:38.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App