Optimal HDD bios settings

Hi,

I have a WD5000AADS-00L4B1 500gb SATA II Hard disk connected to a Gigabyte GA-EX58-UD3R mobo. I would like to set my system to the optimal performance settings. Could someone please provide guidance on the best settings for the following;

The Bios settings for this mobo include..

SATA RAID/AHCI mode (ICH10R); Currently disabled; Options Disabled, AHCI, Raid

SATA Port 0-3 Native mode; Currently Disabled (Legacy IDE mode); Options: Disabled (legacy), Enabled (Native)

Onboard SATA/IDE Device; Currently Enabled (Enables the Gigabyte SATA2 chip); Options Enabled, Disabled;

Onboard SATA/IDE Control Mode (Gigabyte SATA2 chip); Currently IDE, Options: IDE, AHCI, RAID/IDE.

There appears to be no other storage related settings (other than autodetection of drivers, boot sequence and S.M.A.R.T. capability - which is enabled).

What would be the optimal performance settings for this system, given it is running Win 7 Ultimate x64, 6gb DDR3 1600mhz RAM with a single HDD, and 2 DVD RW drives and a GTX260 graphics card.

thanks

the HDD is fastest in AHCI mode but you have to modify the Win7 registry first to enable it if it is not a clean install

Right, so after I modify the registry AHCI setting, and the BIOS it will look like;

AHCI
Enabled
Enabled
AHCI

And I'll move my HDD connector to the GSATA2 connector (it's currently on SATA_0).

Yanta said:

...

And I'll move my HDD connector to the GSATA2 connector (it's currently on SATA_0).

if your mobo requires to move the port do it - the AHCI driver should give you ~10-15% better performance over ide, all depending on the HDD, when it is working correctly.

I purchased a seagate ST3500418AS and reinstalled Windows with AHCI turned on and connected the drive to the gigabyte sata connector rather than the intel sata connector.

My HDD average read performance is now 104mb/s whereas on the WD it was 69.4. My average seek time is 14.1ms and on the WD is was 14.7.

I know the Seagate is a better performer than the WD anyway, but I think the exercise was worth it. Overall my system seems much more responsive now.

MyWin7 said:

Yanta said:

....

My HDD average read performance is now 104mb/s whereas on the WD it was 69.4. My average seek time is 14.1ms and on the WD is was 14.7.

I know the Seagate is a better performer than the WD anyway, but I think the exercise was worth it. Overall my system seems much more responsive now.

My WD's peek at 90MB/s on AHCI
your WD value of 69.4 suggests it run in sata/ide mode and not really AHCI

Correct, but we knew that already, that's the reason for the original post
My WD peaked at 100.1, but averaged 69.4.

Yanta said:

I purchased a seagate ST3500418AS and reinstalled Windows with AHCI turned on and connected the drive to the gigabyte sata connector rather than the intel sata connector.

My HDD average read performance is now 104mb/s whereas on the WD it was 69.4. My average seek time is 14.1ms and on the WD is was 14.7.

I know the Seagate is a better performer than the WD anyway, but I think the exercise was worth it. Overall my system seems much more responsive now.

This may be a stupid question but.. Whats a gigabyte sata connector as opposed to an Intel sata connector? And How do I know if I have one?