|20 Sep 2010||#1|
| || |
Trying To Wipe Drive Using Darik's Boot And Nuke
I have two old hard drives I am trying to sell, one I had to send to get repaired so they sent me a new one but the other one is used. I'm trying to sell them as a pair and finally found a buyer but at the same time I realize that just because the Drive is "RAW" doesn't mean it doesn't have data on it.
It is a WD 74GB Raptor that was in a RAID-0 set-up. I put it in my external enclosure and hooked it up through he eSATA (Didn't know if it would work)
The newest version has no config file. So I went back to the 1.0.7 version.
After starting DBAN interactive mode the following appears, "dban has finished due to a non-fatal error"
I tried unplugging the External Enclosure with the drive but it still did the same thing.
Anyone know of a fix for this program since so far its been unsuccessful? If not a better way I could wipe the drive while in its "RAW" state?
Thanks in Advance
|My System Specs|
|Similar help and support threads for2: Trying To Wipe Drive Using Darik's Boot And Nuke|
|Darik's Boot and Nuke - Use to Secure Wipe a Hard Drive||Tutorials|
|No Internet with New Windows 7 Install after using Darik's Boot & Nuke||Installation & Setup|
|Hard Drive Wipe||Software|
|Hard drive wipe -- dban||Hardware & Devices|
|Need UNattened Boot/Nuke HDD - anyone have iso?||Software|
|Hard Drive Wipe Out||Installation & Setup|
|Can I wipe 7 in dual boot and start over?||Installation & Setup|
|Our Sites ||Site Links ||About Us ||Find Us |
© Designer Media Ltd
All times are GMT -5. The time now is 03:57 AM.