Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.

Windows 7: Dual Boot Installation with Windows 7 and XP

22 Jun 2011   #1320

Microsoft Community Contributor Award Recipient


Quote   Quote: Originally Posted by Wood View Post
Theog - thanks for the quick reply!

1) Win xp is not happy using the Marvell controller, use the Intel.
Does this mean that I will need to disconnect my HD from the Marvell SATA connector on my motherboard, and plug it into one of the Intel SATA connectors?
Will that cause any problems with my current install of Windows7?

2) Win xp is not happy with more than 4gb of ram.
I am probably not going to take out RAM, so does that mean I should abandon trying a dual boot of XP? I read on one site that I should pull some RAM, install XP and then re-insert the RAM after the install is complete. Is that good advice? It seemed a little scary to me.

3) When slipstreaming the Intel drivers, best to add all the controllers,
using both setup inf files.
Thanks! I can give this a try. Should I avoid slipstreaming the Marvell drivers altogether and only slipstream the Intel drivers?

Thanks for the help!
1) yes, but you need to do a Startup Repair on Windows 7
Startup Repair
Note: You may need to do startup repair 3 to 4 times.
Startup Repair - Run 3 Separate Times

2) pull some RAM out, would be worth a try.

3) would be worth avoiding the Marvell drivers altogether

My System SpecsSystem Spec
22 Jun 2011   #1321

windows 7 32bit
dual boot with windows 7 and xp

hi your tutorial was really helpfull i only have a problem at the end. when i select windows 7 it works find but when i select windows xp it comes to a blank black screen and no massage. also when i insert the xp disk nothing happen.

please help.
My System SpecsSystem Spec
22 Jun 2011   #1322


Which Method in the tutorial did you use? Were all steps followed exactly?

Please post back a screenshot of your maximized Disk Mgmt drive map with listings, using Snipping Tool in Start Menu. Tell us what's on each partition.

If you used EasyBCD 2.02, please also post a screenshot of its listings.
My System SpecsSystem Spec
22 Jun 2011   #1323

windows 7 32bit

windows 7 was install first and ai followed all the step to the end with no problem.

Attached Thumbnails
Dual Boot Installation with Windows 7 and XP-capture.png  
My System SpecsSystem Spec

22 Jun 2011   #1324

windows 7 32bit

i used easybcd 2.1

Attached Images
Dual Boot Installation with Windows 7 and XP-capture-01.png 
My System SpecsSystem Spec
22 Jun 2011   #1325


The drive is not showing correctly for XP in the EasyBCD listings.

What I would do is choose Easy's "Edit Boot Menu" tab then highlight and delete the XP listing.

Next choose Add New Entry tab and add XP with correct drive letter D as seen from Win7. Save and restart.

See if that helps.
My System SpecsSystem Spec
22 Jun 2011   #1326

windows 7 32bit

i done it but it still gives me the same problem
My System SpecsSystem Spec
22 Jun 2011   #1327

windows 7 32bit

here is the listing of easybcd after i done it

Attached Images
Dual Boot Installation with Windows 7 and XP-capture02.png 
My System SpecsSystem Spec
22 Jun 2011   #1328


I'd run a Repair Install on XP, or reinstall it.

Then start Win7 by marking it Active in XP Disk Mgmt, booting Win7 DVD Repair Console or Repair CD to run Startup Repair up to 3 separate times with reboots until Win7 starts on its own.

Then add XP from Win7 using EasyBCD 2.02.

Have you tried installing your XP programs to Win7 using Compatibility Mode or virtualizing XP in Win7 using VirtualBox, VirtualPlayer, or VMWare freeware? A lot easier.
My System SpecsSystem Spec
24 Jun 2011   #1329

Windows 7 Ultimate SP1 x64 and Windows XP Professional SP3 x32 (Dual Boot)

Just wanted to say thanks for the tutorial, Brink! I used it back in November when I needed it install XP as a Dual Boot along with the Windows 7 that was already in there.

I have an Acer Aspire 5732Z, so I couldn't (and still can't) load XP (and the boot disk) right off the bat, since I needed to change the BIOS setting from AHCI to IDE (and have to switch to AHCI for 7). After I installed XP, try as I could with VistaBootPRO, I couldn't get the Boot Manager to show up, and it was problematic since my laptop didn't come with a Windows 7 installation disk. Luckily, I just went to the Boot Menu and picked "Boot from Hard Drive", and just like that, Windows 7 was able to load. Then, I was able to use VistaBootPRO to set up the Boot Screen.
My System SpecsSystem Spec

 Dual Boot Installation with Windows 7 and XP

Tutorial Tools Search this Tutorial
Search this Tutorial:

Advanced Search

Similar help and support threads
Windows 7 Tutorial Category
Dual Boot Installation with Windows 7 and Vista
How to Setup a Dual Boot Installation with Windows 7 and Vista This will show you how to install Windows 7 and Vista to dual boot with when you already have either Windows 7 or Vista installed first.With a dual boot installaton, you will have two operating systems (OS) installed. When you start...
Dual Boot Installation with Windows 7 and 7 on 2 separate HDD
1. I have Windows 7 (64 bit) ALREADY installed on a SINGLE hard drive. 2. I have a clean blank other SINGLE hard drive upon which I will install Windows 7 (32-bit). 3. Please understand this is TWO individual hard drives, I want an Operating System installed on each individually. (win7 on ONE,...
Installation & Setup
Dual Boot Installation with Windows 7 and XP
I used to have a computer with Windows XP on which I could use Microsoft Works 2002 "Picture It 7". I now have a laptop with Windows 7 which does not have Microsoft Picture It and I believe that application was discontinued. I still have the old software but cannot use it with Windows 7 only with...
General Discussion
Re-installation of Windows 7/64 on SSD from Dual Boot
Hello, I'll give the "2 cent version" of my situation. I have a dual-boot system (XP on mechanical HDD / Win 7/64 Pro on SSD). Recently, I had a series on infections damage my XP installation irrepairably and it is now time to move everything over to 7. I've just purchased a larger SSD to...
Installation & Setup
dual boot windows 7 and xp installation problem
Hi, I tried installing windows xp on my dell laptop running windows 7.The installation started but soon i got the error message "setup is stopping to prevent any damage to your computer.check your hard drive to make sure its configured sfc on your hard drive etc etc ...
Installation & Setup
Can't Get a Dual-Boot Windows 7/Ubuntu Installation Going
I have two hard drives on my computer, one for my OS and apps (C:), and one for my data (D:). I recently reformatted my C: drive, re-installing Windows 7. I want to set up a dual-boot system with Ubuntu 10.04. The problem I am having is that the Ubuntu installer recognizes my D: drive but not...
Installation & Setup

Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 02:35.

Twitter Facebook Google+

Windows 7 Forums

Seven Forums Android App Seven Forums IOS App