Hardware-assisted Virtualization is Not Enabled


  1. Posts : 294
    Win 7 Pro 64
       #1

    Installation Path Problem? Tried to Move XP Mode Folder


    See my reply below. I got past the installation but followed MS suggested paths created a new problem.


    I would like to download and use XP Mode.

    I have Win 7/Pro x64 installed, authenticated, and running

    Here are my system specs that might apply to my problem:

    Board: Gigabyte Technology Co., Ltd. GA-EP35-DS3P
    BIOS: Award Software International, Inc. F6 06/18/2009
    Processor: Intel Core 2 Quad Q6600 (2.4 GHz) Quad Core
    Controller: Intel P-35 ICH9R Controller 82801IR with AHCI and RAID Support


    I downloaded the MS Hardware-Assisted Virtualization (HAV) Detection Tool and got the error message:


    "Hardware-assisted virtualization is not enabled on this computer." This is a subtly different message than


    "In the Advanced BIOS Features section of my MOBO manual I read that Virtualization Technology enables or disables Intel Virtualization Technology. Virtualization enhanced by Intel Virtualization Technology will allow a platform to run multiple operating systems and applications in independent partitions....."



    I read that I might have to disable this feature, shut down (not just reboot) and then re-enable the feature and shut down and reboot again to really enable virtualization.


    Virtual XP says that "hardware assisted virtualization" disabled in BIOS but it is enabled!



    I tried this and I still get the same answer form the HAV tool. Is Intel Virtualization Technology 'fake hardware virtualization' in the way that Intel's RAID software is seen as 'fake RAID' or am I missing something? Perhaps it is as plain as what is left of the hair on the top of my head (not much) but all I can see is the trees, not the forest.

    I read more carefully and discovered that I had authenticated but not validated by installation of Windows 7/Pro x64. Is there yet another step I've not yet discovered?

    Thanks,


    baumgrenze
    Last edited by baumgrenze; 12 May 2014 at 18:10. Reason: To change title
      My Computer


  2. Posts : 294
    Win 7 Pro 64
    Thread Starter
       #2

    Installation Path Problem? Tried to Move XP Mode Folder


    I managed to get past this hurdle.

    I downloaded and installed XP Mode and it was saved to "Program Files" not to "Program Files (x86)/Windows Virtual PC

    I dragged the entire XP Mode folder to the latter.

    I tried to open XP Mode and the system started to do the whole download from MS again, so I stopped and came here.

    Are there some entries elsewhere that don't get moved with the files themselves, registry entries or .ini file entries?

    Do I need to do a complete uninstall and reinstall? I still have the downloaded installation file for XP Mode that worked, I just don't want to dig a deeper hole than I already have.

    Thanks,

    baumgrenze
    Last edited by baumgrenze; 12 May 2014 at 18:06. Reason: To add a title
      My Computer


  3. Posts : 17,545
    Windows 10 Pro x64 EN-GB
       #3

    I am a bit lost here. Why did you move the XP Mode?

    The whole procedure is really simple following these instructions: Windows XP Mode - Install and Setup.
      My Computer


  4. Posts : 294
    Win 7 Pro 64
    Thread Starter
       #4

    Thank you for your reply, Kari,

    Correct me if I am wrong, but XP Mode needs to be under "Program Files (x86)/Windows Virtual PC" and not under "Program Files."

    I made the mistake of trusting the MS install routine suggested location for installing XP Mode and it ended up in the latter. I tried to open it and nothing happened. I went back to the tutorial and it pointed out the correct "..(x86).." location. That is why I moved it using Windows Explorer, drag-and-drop. I moved the whole directory.

    As I said, now I could find and open it, but when I tried it started to download XP Mode all over again. That seemed a bad path to follow, so I stopped and asked for advice. Vaguely remembered past experience with XP suggested that simply moving a directory of installed files might not be sufficient. That is why I suggested that perhaps I need to delete and reinstall XP Mode to get it in the right place with all associated entries also properly made and accounted for. If this is the case, do I need to drag it back where it was first installed to uninstall it?

    thanks

    baumgrenze
      My Computer


  5. Posts : 17,545
    Windows 10 Pro x64 EN-GB
       #5

    baumgrenze said:
    Correct me if I am wrong, but XP Mode needs to be under "Program Files (x86)/Windows Virtual PC" and not under "Program Files."
    Consider yourself corrected. That is wrong.

    First some philosophical pondering...

    If there's something, a procedure or such that the user does not know and of which the user has no prior experience or knowledge, and further when clear and logical, valid instructions exist, why do users still decide "I think that should go there instead" and do against these clear, valid instructions?

    That being said, installing Windows XP Mode does not mean you install a program. It's just a virtual hard disk image (not a program) to be used with Windows Virtual PC and does not even ask where you want to place it. It will always be placed in C:\Program Files\Windows XP Mode folder, both on X86 and X64 systems.

    As it is not a program, it of course cannot be run alone. Like any virtual appliance it needs a virtualization program to be run, in Windows XP Mode's case it needs Windows Virtual PC virtualization software.

    As instructed in all tutorials I have seen, after you have downloaded the Windows XP Mode virtual hard disk, you need to download and install Windows Virtual PC (VPC). Only after installing VPC and a reboot can you launch the Windows XP Mode virtual machine.

    An excellent tutorial from our admin Brink: Windows XP Mode - Install and Setup

    My recommendation: uninstall XP Mode, and if you have already installed it, the VPC, too. Reboot. Now follow the instructions in above mentioned tutorial to the letter.

    Please notice that when uninstalling Windows Virtual PC it cannot be found in Programs and Features list of installed software, but instead from Installed Updates:

    Hardware-assisted Virtualization is Not Enabled-2014-05-13_21h24_14.png

    Although not a program as told above, Windows XP Mode virtual hard drive can be uninstalled from Programs and Features list of installed software.

    Kari
      My Computer


  6. Posts : 294
    Win 7 Pro 64
    Thread Starter
       #6

    Thank you Kari for your patient and thorough answer.

    I managed to get XP Mode up and running last night. I installed PhotoShop Elements 6 only to discover a problem. It would not authenticate. I sent in the S/N and I got the message "A problem was encountered while trying to send information over the internet." Today I learned that their servers were/are down. That sent me on a wild-goose-chase!

    I now see that I should have tried installing all my legacy x86 software under Win7/Pro x64 just to see if it would work. The Windows Upgrade Advisor Report suggested I obtain 'paid updates' for all of the software because 'we don't have compatibility information about this version of the program.'

    MS Office 2000 (Ver. 9.0.2720), Acrobat Professional 8.1, PhotoShop Elements 6.0, and Autosketch 9 all appear to install, open, and run just fine. The Adobe products have been a headache. I managed to get PSE authenticated earlier this evening when i installed it under Win7. Just a few minutes ago Acrobat Professional returned the
    "A problem was encountered while trying to send information over the internet" message again. It must be difficult running a software company, trying to replace stand-alone desktops with 'cloud computing' and then encountering server problems.

    I hope my story will help others to avoid the mistakes I made.

    Thanks again for your patience.

    baumgrenze
      My Computer


  7. Posts : 17,545
    Windows 10 Pro x64 EN-GB
       #7

    Error message you are getting usually means that there's no active Internet connection. Have you tried to surf the web from your XP Mode? Does Internet work on it?
      My Computer


  8. Posts : 294
    Win 7 Pro 64
    Thread Starter
       #8

    Kari,

    Thanks for the reply.

    When I installed Adobe software under Win7, when my internet connection was as good as it gets, one application (PSE) was registered and another (Acrobat Professional) returned the same error message. I'd done a Live Chat earlier in the day and was told, 'sorry, but our servers are down.' I did a search and it appears to be a common occurrence.

    I'm pleased I don't need to use XP Mode. When time permits, I intend to uninstall it. Should I ever decide I need it again, thanks to your persistence I now know how to install it.

    thanks,

    baumgrenze
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 17:57.
Find Us