Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: error on update

25 Nov 2010   #1
zikmoshe

windows7 ultimate x32
 
 
error on update

When installing kb972813 (heb) on w7 ,( english )I get error 80070571


My System SpecsSystem Spec
.

25 Nov 2010   #2
Hopalong X

Windows7 Pro 64bit SP-1; Windows XP Pro 32bit
 
 

Windows Update error 80070571

Take a look at this.

Quote:

You must be logged on as an administrator to perform these steps.
  1. Open Computer by clicking the Start button , and then clicking Computer.
  2. Right-click the hard disk that Windows is installed on (usually drive C), and then click Properties. The drive that Windows is installed on displays the Windows icon.
  3. Click the Tools tab, and then, under Error-checking, click Check Now. If you're prompted for an administrator password or confirmation, type the password or provide confirmation.
  4. Select both the Automatically fix file system errors check box and the Scan for and attempt recovery of bad sectors check box, and then click Start.
  5. Depending on the size of your hard disk, this may take several minutes. If you're prompted to reschedule the disk check for the next time you restart your computer, close all programs and restart your computer before proceeding to the next steps.
Note

For best results, don't use your computer for any other tasks while it's checking for errors.


My System SpecsSystem Spec
25 Nov 2010   #3
SledgeDG

Windows 7 Ultimate x86
 
 

Have a look here: Windows Update error 80070571
Microsoft says
Quote:
If you receive Windows Update error 80070571 while installing updates, it's usually because the update content isn't valid and could be corrupted. This most likely is the result of a disk error. To resolve the problem, follow the steps below, and then try to check for Windows updates again.
Remedy:

Quote:
You must be logged on as an administrator to perform these steps.

  1. Open Computer by clicking the Start button , and then clicking Computer.
  2. Right-click the hard disk that Windows is installed on (usually drive C), and then click Properties. The drive that Windows is installed on displays the Windows icon.
  3. Click the Tools tab, and then, under Error-checking, click Check Now. If you're prompted for an administrator password or confirmation, type the password or provide confirmation.
  4. Select both the Automatically fix file system errors check box and the Scan for and attempt recovery of bad sectors check box, and then click Start.
  5. Depending on the size of your hard disk, this may take several minutes. If you're prompted to reschedule the disk check for the next time you restart your computer, close all programs and restart your computer before proceeding to the next steps.

Note

For best results, don't use your computer for any other tasks while it's checking for errors.
I hope that solves your problem
Happy Thanksgiving
-DG

Edit: I see Hoppy was faster this time
My System SpecsSystem Spec
.


25 Nov 2010   #4
Hopalong X

Windows7 Pro 64bit SP-1; Windows XP Pro 32bit
 
 

Fastest mouse in the west pardner!
My System SpecsSystem Spec
25 Nov 2010   #5
The Howling Wolves

Windows 7 Home Premium 64bit
 
 

Quote   Quote: Originally Posted by Hopalong X View Post
Windows Update error 80070571

Take a look at this.

Quote:

You must be logged on as an administrator to perform these steps.
  1. Open Computer by clicking the Start button , and then clicking Computer.
  2. Right-click the hard disk that Windows is installed on (usually drive C), and then click Properties. The drive that Windows is installed on displays the Windows icon.
  3. Click the Tools tab, and then, under Error-checking, click Check Now. If you're prompted for an administrator password or confirmation, type the password or provide confirmation.
  4. Select both the Automatically fix file system errors check box and the Scan for and attempt recovery of bad sectors check box, and then click Start.
  5. Depending on the size of your hard disk, this may take several minutes. If you're prompted to reschedule the disk check for the next time you restart your computer, close all programs and restart your computer before proceeding to the next steps.
Note

For best results, don't use your computer for any other tasks while it's checking for errors.


Hoppy,
Good advice! Turn off other programs while checking for errors.
Would rep you but must spread the ---- around.
Slowest fingers in Northern California.
My System SpecsSystem Spec
26 Nov 2010   #6
zikmoshe

windows7 ultimate x32
 
 
error in update

Sorry, but running chkdsk is not solving the problem
Thnx
My System SpecsSystem Spec
26 Nov 2010   #7
Hopalong X

Windows7 Pro 64bit SP-1; Windows XP Pro 32bit
 
 

Try this next and see if it will reset update and install properly.

Windows Update - Reset

If that doesn't work try the below link. Run this up to three times to fix registry. It will tell you it is done and can't fix everything. Run it again. It takes multiple passes to repair everything.
SFC /SCANNOW Command - System File Checker

Mike
My System SpecsSystem Spec
Reply

 error on update




Thread Tools





Similar help and support threads
Thread Forum
Windows 7 - Update KB976932 and KB982526 update failure- error 800b100
Hey, I'm trying to install update KB976932 (Windows Service pack 1 for 64bit) and KB982526 (Microsoft .NET Framework 3.5 SP1) but I keep getting error 800b100 which stops me from doing so. I've tried deactivating my firewall; manually installing from the microsoft website; and using the...
Windows Updates & Activation
Windows Update Error 80070002 & Windows Update Diag Error 0x8007370B
ASUS Desktop PC CM6850 Series Windows 7 Home Premium SP1 64-bit Core i7 4GB RAM 500GB HDD Windows updates not working for a while. Initial was 8007370B appearing in the Windows Update window when searching for updates. Found bad memory using Memtest86+ and pulled the stick. Other stick...
Windows Updates & Activation
Update Error Code 80073712-Cumulative Security Update IE11, Win 7(64)
I'm having no luck installing KB2977629 (Cumulative Security Update IE11). I repeatedly get the error 8007371B. SURT installs with no errors. SFC /SCANNOW runs with no errors. I am uploading the requested screenshots and ZIP file. Any help would be appreciated. Thank you!!!! ...
Windows Updates & Activation
Win7 home update fails, error 8007370B - cannot update, install SP1.
Running Windows 7 Home Premium x64 Cannot update, attempting to upgrade to Win 7 professional. Discovered automatic updates were fried for some time and the system did not have SP1, which is apparently required for the upgrade. I see similar threads, each seems to require advanced...
Windows Updates & Activation
Windows Update fails in Update Check. Error code C80003FA.
Hello, I recieve error C80003FA whenever I do a Windows Update run. It doesn't get past the stage of checking for updates. I've tried several fixes including: - Waiting 15 minutes and running Windows Update again. - Letting Windows Update run on its own schedule. - SFC /Scannow -...
Windows Updates & Activation
Multiple Update Failures / Win7 x64 - Unable to Update, Error 800b010
My problems are essentially those expressed in many previous posts, but specifically this one here was most pertinent (aside from the specific updates of course): http://www.sevenforums.com/windows-updates-activation/155225-win7-x64-unable-update-error-800b0100.html Here is a list of the updates...
Windows Updates & Activation

Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 04:28.

Twitter Facebook Google+



Windows 7 Forums

Seven Forums Android App Seven Forums IOS App