Failure Configuring windows updates, Reverting changes Error


  1. tonyhatomoki
    Posts : 3
    Windows 7 Home Premium 64bit
       New #1

    Windows Update Error 80070002 Installing Update (In thread)


    cumulative security update for internet explorer 11 for windows 7 for x64-based systems
    is the error I get when I try to install it, I've tried fix it, system readiness tool, registry fixers, registry reset, and still I get it, but I've done a lot of research and the only conclusion I can come up with is I have corrupted something I don't know. Please don't answer if your going to give me a link for "Checking" updates error 8007002. This is only happening to this specific update.
      My Computer
    Quote Quote

  3. tonyhatomoki
    Posts : 3
    Windows 7 Home Premium 64bit
    Thread Starter
       New #2

    Failure Configuring windows updates, Reverting changes Error


    Ok when I restart my computer to configure updates, it goes up to 90% and then says that. But it reboots again and tries to configure a second time but still says failure, it does this 3 times and then I can log in. I think it may have something to do with the error (on my other thread) I have on a update and its affecting this, but I don't know what the problem is. If you see the picture, imagine seeing that one time and it reboots and says that 2 more times. That's what's happening to me.
    Last edited by tonyhatomoki; 20 Oct 2014 at 15:19.
      My Computer
    Quote Quote

  4. NoelDP
    Posts : 21,482
    Win 7 x64 Home Premium (and x86 VirtualBox VM)/Win10
       New #3

    Please follow the Windows Update Posting Instructions and post the requested data
    If the file is too large (8MB compressed), remove the older CBSPersist cab files until the final file is below the limit - you can always post them separately after zipping them. (the forum doesn't allow the upload of bare CAB files, for a number of reasons)
      My Computer
    Quote Quote

 

  Related Discussions
Do not turn off your computer. I have been stuck in this loop since this past Sunday. I am running a Dell OptiPlex 745 with windows 7 pro 64bit. I had been doing some cleaning and updating of drivers and software, windows updates were not included in this, and everything was fine, until one of my...
So, Ive been confronted by this problem for quite some time and am at a loss at what to do now. I'd like to start with some background information. While updating Windows 7 Ultimate 64x I experienced a power outage, and upon restart Windows would stick on "failure configuring windows updates...
I recently tried updating to windows 10 but got update errors, I ran sfc /scannow and found I had corrupted files, however it couldn't fix them. I tried everything and had to resort to upgrading windows 7 again to repair all windows files. This required me to install updates again. I downloaded and...
It's been about two months since i last used my laptop and for some reason i haven't been able to successfully update windows. I have tried SURT but with no success. I have my CBS linked on this post, hopefully that will be enough to diagnose what is going on with my laptop. ...
Failure configuring Windows Updates, Reverting changes system: Windows 7 Ultimate 32 bits - system is in Spanish. I followed all kinds of procedures on even more forums but no solution. 1. System Update Readiness Tool (SURT) - KB947821 installed!
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 08:45.
Find Us