New
#131
I think it can be dangerous intruding into your recovery partition and you should definitely check that you can at least initiate a factory recovery.
I think it can be dangerous intruding into your recovery partition and you should definitely check that you can at least initiate a factory recovery.
There´s no problem it works:) anywayzz thank you man
Hi Greg,
Gave this a shot.
Tried both Seatools and the
WD program, neither would work.
Couldn't image my disc with either reflect or acronis.
Instead, just copied my data to my external disc.
Then did a factory reset.
Seemed to work: the computer is now starting up OK, but running very slowly.
I figure the HD is bust. I've got another 2.5" SATA which I could replace it with: is it likely to be possible and safe to clone the current disc to the new one?
(to top this all off, I spilled liquid on my keyboard which is also broken!)
Thanks again for your help,
Angus
You can determine your HD's condition with certainty by runninng maker's HD Diagnostic extended CD scan.
Then run Disk Check on all partitions.
If you ran Factory Recovery you can improve performance by Cleaning up factory bloatware
hi greg,
I'll run a chkdsk tonight, to see what's what.
I did indeed use those manufacturers' diagnostic tools: both WesternD (my HD's maker) and Seatools.
Is it likely that a dodgy HD is causing my PC's slow performance?
Will feed back the chkdsk results tomorrow.
Thanks,
Angus
What is the HD make, and did you run the maker's extended CD scan?
Hi Greg,
I've attached the results of the chkdsk I ran.
It seemed to run successfully this time, but I'm pretty sure I ran it before, and it couldn't complete (maybe due to 'bad sectors')
My HD's maker is Western Digital: It's a Scorpio Blue 3200 BEVT (see: WD Support / Downloads / WD Scorpio & AV-25)
I did run the bootable diagnostics CD: I tried both the short and the long scan, and neither could complete.
Cheers,
Angus
Hi Greg,
I'm pretty sure I downloaded the right program. Although, I might have another go at running the diagnostic, just in case it works.
I've now got another HD (from my old Acer laptop) to hand: I was planning to clone my current HD onto it. Are there any things I need to worry about (e.g. faults on the current HD moving on to the new one)? I was planning on using the Acronis program that is also downloadable from the webpage you posted above. It seems to have a cloning utility. Do I simply hook up the 'new' HD through USB (I've been using it as an external HD), click the clone button, then switch them? Or are there other things I should do first for security/best results?
Thanks again!
Angus
You can certainly try it using that excellent premium Acronis cloning app, then run a Disk Check
on the clone after it starts up - sometimes requiring Startup Repair - Run 3 Separate Times.
Read the attached Manual there.