Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Random BSOD. Reports attached

30 Jan 2011   #51
Akira181

Windows 7 Professional x64
 
 

okay, with only stick 1:

Slot 1 - 666Mhz (DDR1333)
Slot 2 - 200Mhz (DDR400)
Slot 3 - 666Mhz (DDR1333)
Slot 4 - 200MhZ (DDR400)

Slot 1&2 - 666Mhz (DDR1333) - errors in memtest
Slot 1&3 - 666Mhz (DDR1333)
Slot 2&4 -
Slot 3&4 - 666Mhz (DDR1333) - errors in Memtest


My System SpecsSystem Spec
.
31 Jan 2011   #52
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

Did you clear the CMOS after loading BIOS f4?

Disable the AMD K8 Cool&Quiet control in BIOS, see if that has any effect.

Are you still in un-ganged mode?

Is your CPU-NB voltage at 1.3v?
If not bump the voltage and test in slot 2 or 4. If it shows 200MHz, stop the test.

Did you test in slots 2&4? That is memory channel 1, the one giving you problems.

Looks like your having a memory controller issue, channel 1, slots 2&4 are not able to run the RAM at the proper speed.

If none of the above helps, you should consider to RMA the CPU, so far the memory controller looks to be the cause.
My System SpecsSystem Spec
31 Jan 2011   #53
CarlTR6

Windows 7 Ultimate 32 bit
 
 

Good diagnosis, Dave.
My System SpecsSystem Spec
.

31 Jan 2011   #54
Akira181

Windows 7 Professional x64
 
 

I did not clear the CMOS after the new BIOS, CPU NB is at 1.3V and still in unganged mode.

I will try disabling Cool&Quiet tonight as well as slots 2&4. I am convinced the RAM is fine after all these tests and it's the CPU,

I just hope I still have the heatsink that came with it, not quite sure where it is, although I do have one from my Athlon II 4600+ that looks similar.

Thanks again for the help guys
My System SpecsSystem Spec
31 Jan 2011   #55
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

Your welcome, let us know how the tests go, and what you decide to do.


Thanks Carl.
My System SpecsSystem Spec
31 Jan 2011   #56
Akira181

Windows 7 Professional x64
 
 

slots 2&4 still show 200MHz with cool&quiet turned off, CPU NB 1.3V and DRAM 1.64V.

Initiated the RMA for the CPU but think I threw the orignal heatsink away since I use an aftermarket one I still have one from an AMD Athlon II 4600+ but there's a code on the side so they can probably find out. Quite annoyed at that cause that'll screw up the RMA. Might chance it with that heatsink in the hope they don't look so closely.

Either that or I'll just stick with the RAM in single channel for now until AMD release the bulldozer architecture. If that even comes near the Sandy Bridge I won't be too upset.
My System SpecsSystem Spec
31 Jan 2011   #57
Dave76

Microsoft Community Contributor Award Recipient

Windows 7 Ult x64 - SP1/ Windows 8 Pro x64
 
 

You might get lucky or they just might send the same stock cooler back.

Let us know how it's going.
My System SpecsSystem Spec
Reply

 Random BSOD. Reports attached




Thread Tools




Similar help and support threads
Thread Forum
Error 0x124 with reports attached
I built my PC a few months ago (November 2014) and its been having error 0x124 since its first boot up and I did some research finding out that its related to hardware problems or in "rare" cases just a driver problem. To also mention that it completely stops and just resets with no Blue Screen...
BSOD Help and Support
Random BSOD .dmp attached
Need debug help where to start looking
BSOD Help and Support
Random computer freezes and BSOD reports
Hello all, I have been having a lot of computer freezes, where the computer will just lock up without a BSOD a good 10 times in the last week or so and I haven't been able to find the culprit of this. I have tried to do a chkdsk on all my drives, CPU and RAM tests, but they all come clean. I do...
BSOD Help and Support
BSOD errors in Windows 7 64bit (reports attached) help please
Hello I've just installed the full retail version of W7 64bit and am having regular BSOD crashes and 'Recovered from a serious error' messages. Hardware is 1 year old (Intel DH67GD) i2500K, 12 GB RAM). Any suggestions welcomed, thanks, joe
BSOD Help and Support
BSOD is killing the laptop, error log and performance reports attached
Please help - how to get rid of the Blue Screen Core Dump Problem . System Spec Windows 7 64 bit Original installed OS, OEM. Lenovo Laptop W700, around 3 years old. Thanks
BSOD Help and Support
Random BSoD, Driver Power State Failure, reports blame ntoskrnl.exe
Hello and thanks for letting me post on this awesome forum!!!! I am fixing a family members computer and it has stumped me. I have tried everything that I can find online related to my problem outside of reinstalling but I think it could be a hardware (power or memory) issue from what i read and...
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 16:59.
Twitter Facebook Google+ Seven Forums iOS App Seven Forums Android App