New
#11
Ok no problem will they both take long?
there running now =]
Ok no problem will they both take long?
there running now =]
how do i keep an eye on my temperature? im total noob sorry =[
also the ram one i wont be able to move them around. its warranty
Just run the test on all the sticks at once. That will be enough to prove to Mesh that they need to take care of it.
As for the temperature test, use Speedfan.
SpeedFan - Access temperature sensor in your computer
If im honest i think the update have done it, i been playing games for awhile, if i do gt another bsod then i will do the tests if not i will leave them, but for now thank you so much for ur help!
=]
temp is:
temp 1 :27
temp2: 34
temp 3: -128
HD: 25
core: 13
what temp should they be
Just got a bluscreen after ages bccode 3b well gutted, dno what to do really, mesh arnt helping they were ment to call and havnt im confused.
running the programes again so u can check to see if it was my game that crashed it.
well started to do it halfway throguh
bluescreen - bccode FC
HELP!? please
i checked event viewer and it says something about Kernal-power in system log>?
going to run memtest 86 overnight =]
woop got one pass so far better sleep now. i read on meshownersclub forum that we can break seal and wont void warranty but im a bit hesitant since its like year old..
Last edited by SnEAky; 22 Dec 2010 at 19:33.
Those temps seem fine to me.
I hope the Memtest results are conclusive; a Prime95 failure can be caused by CPU, motherboard, or RAM. In addition, the extra power load may increase the chance that PSU and heat problems will show up.
Try running the Small FFTs Prime95 test, if that's not the one you already ran. In addition, run the Blend test. Be sure to watch Speedfan as you do.
morning just woke to see memtest passed 8 times no failures, whats the best thing to try next? cpu thin for a few hours?
im confused on where or what to do next.
also could it be crashing because i have my old windows installed bcause itried a fresh install, but in c:// windows.old is missing the drivers you asked me to get.
Last edited by SnEAky; 23 Dec 2010 at 03:43.
Prime95 is running, using 100% cpu?
hope thats correct
the temps arnt really rising just the first one temp 1: 50C
shall i leave it run and whats next to try?
UPDATE;
the first has risen to 52C
and the core is at 41C
still no bsod yet.#
UPDATE:
still same temps so i dno wht the problem is, im so confused! jonathon where are you =[
Last edited by SnEAky; 23 Dec 2010 at 04:07.