Getting Random BSOD Errors

i did repair them

Your CBS log file still shows the same corruption. Did you download and burn the Windows 7 ISO and do the Repair Install following the steps in the repair install link?

i fixed the files and sfc even couldn't find any problem. but still system gets shut down with no bsod error at all. log attached.
Attachment 207251

Alright, log looks clean now. Good job!

Let's check hardware since the system shutting down usually indicates a hardware fault or overheating. On the subject of overheating: when was the last time you cleaned the dust out of the system?

To remove dust, follow the subsequent general procedure. If you have a desktop bought from Dell, HP, Sony, Lenovo, etc. make sure removing the desktop casing will not void your warranty first. Call the company if you are still under warranty and ask if it is okay to remove the casing and blow dust out. The procedure described is fine for laptops; just make sure no stickers are on panels saying if you remove the panel it will void the warranty.

1. Shut down and turn off your computer.
2. Unplug all power supplies to the computer (AC Power then battery for laptops, AC power for desktops)
3. Hold down the power button for 30 seconds to close the circuit and ensure all power drains from components.
4. Remove the casing for a desktop, or remove any screwed on panels and disc drives for laptops.
5. Blow out the dust inside by using a can of compressed air or a low pressure compressor. You will want to put the computer on a desk or table so you can maintain the can in an upright position if using a can of air. Blow into all crevices on the motherboard, heat sinks, cards, modules, etc. for a desktop. Blow into vents, opened panels, disc drive areas, USB ports, and the keyboard if it is a laptop. You may also want to blow inside the disc drive by replacing the drive to the laptop, starting the computer, opening the drive, and then turning off the computer and removing all power as described above including the 30 second power button step. For a desktop, you may also want to blow inside the disc drive by starting the computer, opening the drive, and then turning off the computer and removing all power as described above including the 30 second power button step.
6. Replace casing for the desktop. Replace panels and disc drive (if you have not already done so) for the laptop.
7. Plug power supplies in. AC adapter for the desktop. Battery and then AC Adapter for the laptop.
8. Start the computer and see if performance is better.