New
#1
Crashed again (POWER DRIVER STATE ERROR BSOD)
everything is attached
Hello Vesuvius and welcome to Sevenforums!
BSOD Analyse
I'm gonna step right in with Memtest86+ on this one.
Looking at your bugcheck it's likely that a memory corruption event was triggered. Though a driver could be causing the memory to be borked, but we're usually suggesting a memory test before moving forward. Do a scan with Memtest86+. Memtest is a scanner that'll check your sticks for errors.
WarningNote that the below instructions may break your WARRANTY rules. If you're unsure check manuals, separated warranty papers, stickers on computer for secure permission.
To ensure that we'll know if it's the slots on the motherboard that's broken, or the sticks itself - we have a little procedure we'll recommend. Remove 1 stick, scan the other with Memtest in the current slot. After 7 passes, move the stick to another slot and scan, and so on and so forth until you've scanned all the sticks, and all the slots, one by one.
Memtest86+ - Advanced Memory Diagnostic Tool
Best Regards,Bugcheck description
Usual causes: Defective hardware (particularly memory - but not just RAM), Faulty system service, Antivirus, Device driver, NTFS corruption, BIOSCode:PAGE_FAULT_IN_NONPAGED_AREA (50) Invalid system memory was referenced. This cannot be protected by try-except, it must be protected by a Probe. Typically the address is just plain bad or it is pointing at freed memory. Arguments: Arg1: fffffa8c07385feb, memory referenced. Arg2: 0000000000000000, value 0 = read operation, 1 = write operation. Arg3: fffff800030b2e85, If non-zero, the instruction address which referenced the bad memory address. Arg4: 0000000000000005, (reserved)
Frederik.