BSOD - Computer locks up and reboots every 45-60 minutes

ok

1. Disable the "Windows Search Service"

2. Disable the below from startup

IAStorIcon REG_SZ C:\Program Files (x86)\Intel\Intel(R) Rapid Storage Technology\IAStorIcon.exe
Adobe ARM REG_SZ "C:\Program Files (x86)\Common Files\Adobe\ARM\1.0\AdobeARM.exe"
NBAgent REG_SZ "C:\Program Files (x86)\Nero\Nero BackItUp & Burn\Nero BackItUp\NBAgent.exe" /WinStart

ASRockXTU REG_SZ
uTorrent REG_SZ "C:\Program Files (x86)\uTorrent\uTorrent.exe" /MINIMIZED

3. Uninstall the Etron driver you installed now ... to this version which is currently supported by the motherboard... This driver is dated 2/20/2011...

4. What is connected to this USB port ???

also check under bios if USB 3.0 Controller is enabled

Xynie..

Let me know if you BSOD on the 0.96 version of the driver. I have the version 0.101 version that should solve your problem

Completed all requested steps, also ensured version 1.0.0.96 (1/2011) was installed after uninstalling other versions. Same issue, This device cannot start. (Code 10)

BIOS Settings
USB 3.0 Controler - Enabled
USB 3.0 Legacy Support - Disabled

There are no devices plugged into the 3.0 ports, only a few devices (external HDD, Bluetooth Mouse/Keyboard) plugged into 2.0 ports.

ok

here is the 0.101 version... this is know to resolve the issue with your motherboard.

Install this and let me know ....

Uninstalled the old version, installed 0.101. It immediately put up a BSOD, did a CHKDSK, and then rebooted. Strange part is after the reboot I don't see any components with issues (no failed to start messages)... but I also don't see a 3.0 Controller in device manager. It all looks normal, its just not there.

I will let you know if it locks up again over the next hour.

did u check under usb ??? it should be there

Screenshot attached...

weird I just looked at the driver inf file and it shows like this

Etron="Etron Technology Inc."
Etron.Mfg="Etron Technology Inc."
Etron_DISKID = "Etron USB 3.0 Device Driver Installation Disk"
Etron_XHCI.DriverDesc="Etron USB 3.0 Extensible Host Controller Driver"
Etron_HUB3.DriverDesc="Etron USB 3.0 Extensible Hub Driver"
Etron_XHCI.DeviceDesc="Etron USB 3.0 Extensible Host Controller"
Etron_RTH3.DeviceDesc="Etron USB 3.0 Extensible Root Hub"
Etron_HUB1.DeviceDesc="Etron USB1 (FS) Hub"
Etron_HUB2.DeviceDesc="Etron USB2 (HS) Hub"
Etron_HUB3.DeviceDesc="Etron USB3 (SS) Hub"
USBClassName="Universal Serial Bus controllers"

Could you click on the "scan for hardware changes" and see if something comes up

Nope, no new devices found.