Random BSODs, error 0x000000F4

Hello, i experience random BSODs on my PC(1,5 years old) since the day i bought it. I formatted and did a clean install of windows(tried also 32-bit version) many times, but the BSODs keep happening...
I used memtest86+ but it showed that everything is working good. The last BSOD said these:
"***STOP:0x000000F4(0x000000000000003,0xFFFFFA8007F52400,0xFFFFFA8007F526E0,0xFFFFF800031D0460)"
Note that after i reboot my system a warning comes that says that DES 2.0 application(Dynamic Energy Saver) is turned off and i should use DES application to turn it on again.
Also note that after every reboot because of a BSOD, i have to shut down the system and power it up again because it can't load windows...
My system information:
Intel Core i5 2500K @ 3.3 GHz
Gigabyte Z68X-UD3P-B3
Corsair Vengeance 2x4GB
AMD Radeon HD 6950
Corsair AX750
Corsair Force GT 60 GB(OS)
WDC WD1002FAEX 1TB

And the version of Windows i have: Windows 7 Professional 64-bit 6.1.7601 SP1 Build 7601.
For any info i might have forgotten or you may need just tell me.
Thank you for your help, in advance!

Tassos

Welcome

No dump files. Follow: Dump Files - Configure Windows to Create on BSOD

Is the firmware of your SSD up to date?

Upload a screenshot of your hard disk using CrystalDiskInfo:

• CrystalDiskInfo - Software - Crystal Dew World
• Screenshots and Files - Upload and Post in Seven Forums

Make a hard drive test from the hard drive manufacturers website:

• Hard Drive Diagnostic Procedure

Run Disk Check on your hard disk for file system errors and bad sectors on it:

• Disk Check

Every SSD manufacturer I know recommends using AHCI mode to get the best performance from the SSD. However you can use IDE mode if you would rather. Here is a tutorial on how to make the change. AHCI : Enable in Windows 7 / Vista If you would, click, start type device manager in the search box, click on device manager when it appears, and expand IDE/ATA?ATAPI, at the bottom you will see the name of the driver. See if you have one with AHCI in the name. If so let us lnow what the name of it is.

It shouldn't. Switch back to IDE mode, if you like, but typically, AHCI is faster than IDE with an SSD. Try option 2 of this tutorial. SFC /SCANNOW Command - System File Checker