Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.

Windows 7: BSOD after sleep mode

22 Jan 2013   #1

Windows 7 Professional 64 bit
BSOD after sleep mode

I've noticed that my computer shuts off after being in sleep mode for a while. When I reboot and look in EventViewer I find the message: "The system has rebooted without cleanly shutting down first. This error could be caused if the system stopped responding, crashed, or lost power unexpectedly." Locale ID: 1033.

Here's my computer setup:
Operating System
Microsoft Windows 7 Professional 64-bit
AMD Phenom II X6 1100T
Thuban 45nm Technology
8.00 GB Dual-Channel DDR3 @ 715MHz (9-9-9-24)
ASUSTeK Computer INC. M4A79XTD EVO (AM3) 44 C
Generic Non-PnP Monitor (1920x1080@60Hz)
1023MB GeForce GTX 460 SE (EVGA) 30 C
Hard Drives
932GB Seagate ST31000524AS ATA Device (SATA) 30 C

I've attached the zipped files from SF diagnostic tool: Attachment 251524

I will note that I recently did a clean install of Windows 7 and the problem remains. I'm really stumped on how to fix this one. Thank you.

My System SpecsSystem Spec
22 Jan 2013   #2

Microsoft Community Contributor Award Recipient

Windows 10 Home 64Bit

Welcome to SevenForums.

Apparently it looks like MotioninJoy simulate Xbox 360 controller (virtual Xinput device) driver from may is causing the blue screen.
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *

Use !analyze -v to get detailed debugging information.

BugCheck D1, {fffff88001912638, 2, 8, fffff88001912638}

*** WARNING: Unable to verify timestamp for MijXfilt.sys
*** ERROR: Module load completed but symbols could not be loaded for MijXfilt.sys
Probably caused by : MijXfilt.sys ( MijXfilt+1b638 )

Followup: MachineOwner

2: kd> !analyze -v
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *

An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high.  This is usually
caused by drivers using improper addresses.
If kernel debugger is available get stack backtrace.
Arg1: fffff88001912638, memory referenced
Arg2: 0000000000000002, IRQL
Arg3: 0000000000000008, value 0 = read operation, 1 = write operation
Arg4: fffff88001912638, address which referenced memory

Debugging Details:

READ_ADDRESS: GetPointerFromAddress: unable to read from fffff800031050e0
GetUlongFromAddress: unable to read from fffff80003105198
 fffff88001912638 Nonpaged pool


fffff880`01912638 48895c2408      mov     qword ptr [rsp+8],rbx





TAG_NOT_DEFINED_c000000f:  FFFFF88002F93FB0

TRAP_FRAME:  fffff88002f93b50 -- (.trap 0xfffff88002f93b50)
NOTE: The trap frame does not contain all registers.
Some register values may be zeroed or incorrect.
rax=0000000000000000 rbx=0000000000000000 rcx=0000057ff7042d08
rdx=0000057ff6fa0fd8 rsi=0000000000000000 rdi=0000000000000000
rip=fffff88001912638 rsp=fffff88002f93ce8 rbp=0000057ff7042d08
 r8=000000000900c420  r9=0000000000000000 r10=fffffa8008fc96a0
r11=0000000000000002 r12=0000000000000000 r13=0000000000000000
r14=0000000000000000 r15=0000000000000000
iopl=0         nv up ei pl zr na po nc
fffff880`01912638 48895c2408      mov     qword ptr [rsp+8],rbx ss:0018:fffff880`02f93cf0=20f0050980faffff
Resetting default scope

LAST_CONTROL_TRANSFER:  from fffff80002ece469 to fffff80002ecef00

fffff880`01912638 48895c2408      mov     qword ptr [rsp+8],rbx

fffff880`02f93a08 fffff800`02ece469 : 00000000`0000000a fffff880`01912638 00000000`00000002 00000000`00000008 : nt!KeBugCheckEx
fffff880`02f93a10 fffff800`02ecd0e0 : fffffa80`06a21c68 fffffa80`0905f020 00000000`00000000 fffff800`02ed69ba : nt!KiBugCheckDispatch+0x69
fffff880`02f93b50 fffff880`01912638 : fffff880`00eda047 fffffa80`0905f020 fffffa80`08fc96a0 fffffa80`08fc96a0 : nt!KiPageFault+0x260
fffff880`02f93ce8 fffff880`00eda047 : fffffa80`0905f020 fffffa80`08fc96a0 fffffa80`08fc96a0 fffff800`02ed1516 : MijXfilt+0x1b638
fffff880`02f93cf0 fffff880`00ed999f : 00000000`00000000 fffffa80`0905f020 fffffa80`08fbd2f0 fffffa80`08fbd2f0 : Wdf01000!FxIoQueue::DispatchRequestToDriver+0x56f
fffff880`02f93d70 fffff880`00ed8f98 : 00000000`00000000 00000000`00000002 00000000`00000000 fffffa80`0905f172 : Wdf01000!FxIoQueue::DispatchEvents+0x4df
fffff880`02f93de0 fffff880`00ede558 : fffffa80`079a4e02 fffffa80`0905f020 fffffa80`079a4c60 fffffa80`0905f020 : Wdf01000!FxIoQueue::QueueRequest+0x2bc
fffff880`02f93e50 fffff880`00ec8245 : fffffa80`0905f020 fffff880`02f64180 00000000`00000000 fffffa80`0900d538 : Wdf01000!FxPkgIo::Dispatch+0x37c
fffff880`02f93ed0 fffff800`02eda5dc : fffff880`02f64180 00000000`00000000 fffff880`00f77fc0 00000000`00000000 : Wdf01000!FxDevice::Dispatch+0xa9
fffff880`02f93f00 fffff800`02ed5065 : 00000000`00000000 fffffa80`06a1e040 00000000`00000000 fffff880`00eabccc : nt!KiRetireDpcList+0x1bc
fffff880`02f93fb0 fffff800`02ed4e7c : 00000000`00000000 00000000`00000000 00000000`00000000 00000000`00000000 : nt!KyRetireDpcList+0x5
fffff880`03192510 00000000`00000000 : 00000000`00000000 00000000`00000000 00000000`00000000 00000000`00000000 : nt!KiDispatchInterruptContinue


fffff880`01912638 48895c2408      mov     qword ptr [rsp+8],rbx


SYMBOL_NAME:  MijXfilt+1b638

FOLLOWUP_NAME:  MachineOwner


IMAGE_NAME:  MijXfilt.sys



BUCKET_ID:  X64_0xD1_CODE_AV_BAD_IP_MijXfilt+1b638

Followup: MachineOwner

2: kd> lmvm MijXfilt
start             end                 module name
fffff880`018f7000 fffff880`01919000   MijXfilt T (no symbols)           
    Loaded symbol image file: MijXfilt.sys
    Image path: \SystemRoot\system32\DRIVERS\MijXfilt.sys
    Image name: MijXfilt.sys
    Timestamp:        Sat May 12 10:27:12 2012 (4FADE6A0)
    CheckSum:         00022009
    ImageSize:        00022000
    Translations:     0000.04b0 0000.04e4 0409.04b0 0409.04e4
I would check for a update on its driver, or roll back to a last known stable driver and see if that helps resolve the BSOD issue.
My System SpecsSystem Spec
23 Jan 2013   #3

Windows 7 Professional 64 bit

Thank you so much for your help!
My System SpecsSystem Spec

23 Jan 2013   #4

Microsoft Community Contributor Award Recipient

Windows 10 Home 64Bit

You're welcome.
Let us know how it went.
My System SpecsSystem Spec

 BSOD after sleep mode

Thread Tools

Similar help and support threads
Thread Forum
Laptop freezes between entering sleep mode to being in sleep mode
hai.. help needed.... i am having the exact problem as op.. when i press sleep button, screen goes black (as usual).. but fan, and other keyboard lights are still on... it just freezes... i have to force shutdown to again use my laptop... i am attaching the msinfo32.nfo, driverview.txt... ...
General Discussion
Laptop freezes between entering sleep mode to being in sleep mode
Hi, I've had this problem intermittently on my laptop for the past 2 years however it has been occuring more often recently. Basically sometimes when I click the sleep button on Windows 7, the screen fades to black as usual. However the fan keeps running (sounds like when it's on full load) and...
General Discussion
BSOD Going INTO Sleep Mode
To keep it short; I receive a BSOD when I go into Sleep Mode sometimes. It's almost random, but it's not. ie. Like when I'm working on it for a long period of time. I've noticed an issue when I started using Daemon tools, it was almost instantaneously. Windows 7 x86 (but in the Computer...
BSOD Help and Support
BSOD during sleep mode
Hello I've having problems with BSOD after my computer goes to sleep mode. I haven't had a chance to check it out until now, so there are quite a bit of minidump files that have been accumulated. My computer is about 6 years old. All I've done so far is update drivers for my graphic and sound...
BSOD Help and Support
BSOD in sleep mode
My Win 7 professional x64 on a lenovo T500 sometimes restarts during sleep mode and gives me this message: Problem signature: Problem Event Name: BlueScreen OS Version: 6.1.7600. Locale ID: 1033 Additional information about the problem: BCCode: 1000009f ...
BSOD Help and Support

Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 09:46.
Twitter Facebook Google+