Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.

Windows 7: BSOD Problem on start-up, begins a reboot cycle continuously.

09 Jul 2013   #11

Windows 7 Home Premium 64-bit

Oh, got another BLOD, this ones different. This is the first time this ones happened,

Problem signature:
Problem Event Name: BlueScreen
OS Version: 6.1.7601.
Locale ID: 1033

Additional information about the problem:
BCCode: 1000007e
BCP2: 0000000000000000
BCP3: FFFFF8800317F338
BCP4: FFFFF8800317EB90
OS Version: 6_1_7601
Service Pack: 1_0
Product: 768_1

And I don't think I gave memtest enough passes, I'm going to run it again tonight, and all day tomorrow.

My System SpecsSystem Spec
09 Jul 2013   #12
x BlueRobot


BugCheck 1000007E, {ffffffffc0000005, 0, fffff8800317f338, fffff8800317eb90}

*** WARNING: Unable to verify timestamp for MijXfilt.sys
*** ERROR: Module load completed but symbols could not be loaded for MijXfilt.sys
Probably caused by : MijXfilt.sys ( MijXfilt+2033 )
Usual causes:  Insufficient disk space, Device driver, Video card, BIOS, Breakpoint with no debugger attached, Hardware incompatibility, Faulty system service, Memory, 3rd party remote control
4: kd> lmvm MijXfilt
start             end                 module name
fffff880`09953000 fffff880`09975000   MijXfilt T (no symbols)           
    Loaded symbol image file: MijXfilt.sys
    Image path: MijXfilt.sys
    Image name: MijXfilt.sys
    Timestamp:        Sat May 12 05:27:12 2012 (4FADE6A0)
    CheckSum:         00022009
    ImageSize:        00022000
    Translations:     0000.04b0 0000.04e4 0409.04b0 0409.04e4
Your MotioninJoy simulate Xbox 360 controller (virtual Xinput device) driver seems to be a possible cause and causing problems, it is very well known to cause BSODs with Windows 7, as a result I would suggest you check for a update - MotioninJoy simulate Xbox 360 controller(virtual Xinput device) | MotioninJoy
My System SpecsSystem Spec
09 Jul 2013   #13

Windows 7 Home Premium 64-bit

I installed a new version of Motion Joy, so lets hope I never get that BSOD again. Also, I havent had any other BSOD's today, but my CPU temp freaked out and again went to around 220 Degrees Celsius, so I'm still thinking that is a hit or miss problem, and I'm probably not going to play games at high settings, I'll probably tone it down until I get a new case and proper cooling systems. I'll be sure to let you know if anymore BSOD's happen, thank you for all the support.
My System SpecsSystem Spec

10 Jul 2013   #14

Windows 7 Home Premium 64-bit

Okay, it happened again, the same recurring BSOD that I've been having since the beginning, but I think I've isolated as to what the problem is.

I have this wireless receiver for my 360 controller, it isn't genuine (meaning not made by Microsoft), and after I plugged it in and installed the drivers, then reset my system, it began it's cycle again of logging in for a few seconds then rebooting continuously. Now, I'm not 100% positive this is the only thing causing the problem as I haven't tried logging in again, but I'll find out soon enough.
My System SpecsSystem Spec
10 Jul 2013   #15
x BlueRobot


Are you able to boot normally without it plugged in?

BugCheck 124, {0, fffffa800e5a24b8, 0, 0}

Probably caused by : AuthenticAMD
Stop 0x124's are usually always hardware, but can be caused by corrupted or incompatible drivers sometimes.

2: kd> !errrec fffffa800e5a24b8
Common Platform Error Record @ fffffa800e5a24b8
Record Id     : 01ce7d46e66bf2e5
Severity      : Fatal (1)
Length        : 928
Creator       : Microsoft
Notify Type   : Machine Check Exception
Timestamp     : 7/10/2013 8:24:45 (UTC)
Flags         : 0x00000002 PreviousError

Section 0     : Processor Generic
Descriptor    @ fffffa800e5a2538
Section       @ fffffa800e5a2610
Offset        : 344
Length        : 192
Flags         : 0x00000001 Primary
Severity      : Fatal

Proc. Type    : x86/x64
Instr. Set    : x64
Error Type    : BUS error
Operation     : Generic
Flags         : 0x00
Level         : 3
CPU Version   : 0x0000000000600f20
Processor ID  : 0x0000000000000000

Section 1     : x86/x64 Processor Specific
Descriptor    @ fffffa800e5a2580
Section       @ fffffa800e5a26d0
Offset        : 536
Length        : 128
Flags         : 0x00000000
Severity      : Fatal

Local APIC Id : 0x0000000000000000
CPU Id        : 20 0f 60 00 00 08 06 00 - 0b 32 98 3e ff fb 8b 17
                00 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00
                00 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00

Proc. Info 0  @ fffffa800e5a26d0

Section 2     : x86/x64 MCA
Descriptor    @ fffffa800e5a25c8
Section       @ fffffa800e5a2750
Offset        : 664
Length        : 264
Flags         : 0x00000000
Severity      : Fatal

Error         : BUSLG_GENERIC_ERR_*_TIMEOUT_ERR (Proc 0 Bank 4)
  Status      : 0xfe00000000070f0f
  Address     : 0x00000000e0100520
  Misc.       : 0xc00a0fff01000000
My System SpecsSystem Spec
10 Jul 2013   #16

Windows 7 Home Premium 64-bit

Yes, when the wireless receiver is not plugged in, I can log in normally, however, today the same BSOD happened even when it wasn't plugged in. Though, when it was plugged in, the reboot cycle was continuous, and never stopped, sometimes Blue Screening ten times before I gave up, where as when it isn't plugged in, it only Blu Screens once, then everything is fine. There was also a minor issue that happens every now and then where the screen freezes up when I'm playing a game, and has a buzzing, glitchy noise emanating from the speakers, but I think that is probably a overheating issue.

I also noticed that it says "Probably caused by : AuthenticAMD" above, and the only AMD thing that I have in my computer is my processor, so maybe that is the source of the problem. I'm going to try re-seating and re-applying thermal paste to the processor to see if maybe that will solve the problem. I was just hoping that that wasn't the problem earlier, 'cause that can be a bit of a pain sometimes, and messy.
My System SpecsSystem Spec
11 Jul 2013   #17
x BlueRobot


Every Stop 0x124, BSOD will either say AuthenticAMD or GenuineIntel, since usually the CPU finds the hardware error with a Machine Check Exception.

The Xbox 360 Wireless driver is causing the boot cycles, but there' still another underlying problem, hence the BSOD Stop 0x124's still, it is worthwhile reapplying thermal paste to eliminate any CPU overheating issues.

I would also suggest stress testing the graphics card for any issues:
warning   Warning
Read all the steps within the hardware test tutorials very carefully, as stress tests is designed run components to their maximum capacity, in order to point out failing or faulty hardware components

Use the following program to monitor your hardware temperatures during the stress test:
My System SpecsSystem Spec
12 Jul 2013   #18

Windows 7 Home Premium 64-bit

I have already done a few stress tests on my graphics card, and under maximum load it performs quite well, not going over temperatures of around 78 degrees Celsius, and not causing any slow down. But, I really am stuck on thinking it may be my CPU. The thermal paste that was already on the stock heat sink was relatively small compared to the size of the CPU itself, and upon inspection, it doesn't seem to cover all of the surface area of the CPU, and that is mostly due to the space that is slotted out for the CPU on the heat sink being too small to cover the surface area of the CPU. So, after noticing that, I figured why bother replacing the thermal paste, I'm just going to buy a new CPU Cooler and some new thermal paste for it. And if I'm not explaining the situation well enough, I can give you a photo of it if you need one just so that it's easier to visualize how the heat sink interacts with the surface area of the CPU.
My System SpecsSystem Spec
12 Jul 2013   #19
x BlueRobot


I understand what you mean, overheating can be cause, and if the heatsink is too small, then you'll need to get one which fits. Be wary though, since some hardware vendors will state that replacing the stock cooler etc. will void the warranty of the device.
My System SpecsSystem Spec
12 Jul 2013   #20

Windows 7 Home Premium 64-bit

Yeah, and in this case it does state that the warranty will be void. I'm planning on contacting AMD though and seeing if maybe I can keep my warranty because it's not really my fault that the heat sink sucks.

Also, I guess the wireless receiver wasn't the issue of the re-boot cycle, or now it's something else, because last night a never ending reboot cycle happened without the receiver plugged in, I really don't know what to do at this point, I have pretty well every USB port empty besides the mouse and keyboard, so there isn't any external hardware causing an issue. I'm just at a complete loss now. So the only place I feel that I can look is the processor.

Also, I did end up re-seating the processor and re-applying new thermal paste to the CPU and really made sure to cover the whole surface area of it. But, when I fired the PC up, it blue screened 3 times, then now its fine so far. This is only the first time I've logged in since I re-applied the thermal compound, so I'm crossing my fingers.
My System SpecsSystem Spec

 BSOD Problem on start-up, begins a reboot cycle continuously.

Thread Tools

Similar help and support threads
Thread Forum
BSOD 90% on first start up unless I "cycle" ram locations
Hello, I am receiving a BSOD on boot up. The weird part is, if I physically move location of each ram into a different slot I no longer receive the BSOD. I have run MEMTest and it did not indicate any errors. Attached is the MEMORY.dmp. I am away from that computer at the moment but can also...
BSOD Help and Support
Start, CMD, begins at C:\users\username, how do I start at C:\?
I am at the comment prompt or window in windows 7. it begins at C:\Users\alienware I typed CD or cd, and when I hit enter it does nothing. It jumps to the next line with the same command. How do I get it to start at c:\ so I can go to the directory I want? Thanks
General Discussion
Asus G74Sx - Originally BSOD/start up cycle and now CHKDSK/corruption
Hello everyone, My G74Sx recently went through a BSOD/crash loop and although I never determined the underlying cause I did get it working (temporarily) again. I thought it could be my HDD or RAM going bad, but I'm not sure. I may have made things worse. Hope someone here can help me figure...
BSOD Help and Support
Windows 7 Home Premium does not reach login screen - reboot cycle
I have had Windows 7 Home Premium (64 bit) installed on my Gateway NV53 laptop. I must note that my laptop dual boots Windows and Ubuntu 10.04 with GRUB 2 as my default bootloader (which employs a chainloader to boot Windows 7). 4 weeks ago, I began experiencing problems with my Windows partition....
General Discussion
Windows in reboot cycle.
Posted this in general, then realized it's probably better to ask here. Daughter was on her usual morning video skype with her boyfriends in the middle east, when according to her, it said something about a problem with internet explorer "she thinks", then it did a forced shut down. Since...
BSOD Help and Support

Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 01:06.
Twitter Facebook Google+