BSOD: error 1a after playing 2 games of LoL

Page 1 of 2 12 LastLast

  1. Posts : 26
    Windows 7 Home 32 bit

    BSOD: error 1a after playing 2 games of LoL

    98 Percent chance that after 2 games the PC will crash. If I get lucky the 2 percent will prevail and it will crash in the 4th game. After the crash the PC will not boot and will just flash No Signal in the monitor after 5 - 24( if I also get lucky it will boot 5 hours after the Crash)
      My Computer

  2.    #2

    BugCheck 1A, {41287, 6147d, 0, 0}
    Probably caused by : win32k.sys ( win32k!NtGdiSetBitmapBits+46 )
    be8d8c18 -- (.trap 0xffffffffbe8d8c18)
    ErrCode = 00000000
    eax=00061471 ebx=8556c030 ecx=00061471 edx=0000015d esi=8556c2a8 edi=0015dfff
    eip=832ae2dd esp=be8d8c8c ebp=be8d8c8c iopl=0         nv up ei pl nz na pe nc
    cs=0008  ss=0010  ds=0023  es=0023  fs=0030  gs=0000             efl=00010206
    832ae2dd 3b510c          cmp     edx,dword ptr [ecx+0Ch] ds:0023:0006147d=????????
    The trap frame for the exception shows that a Divide Error has occurred, which is usually caused by device drivers. Yet, the bugcheck suggests a illegal page fault has happened during working set synchronization. There is some synchronization present with the release of a queued spinlock in the raw stack.

    1: kd> k
     # ChildEBP RetAddr  
    00 be8d8ae0 83253aa8 nt!MmAccessFault+0x104
    01 be8d8ae0 832ae2dd nt!KiTrap0E+0xdc
    02 be8d8b6c 832adf84 nt!MiFindNodeOrParent+0x17
    03 be8d8b80 832adfd2 nt!MiLocateAddress+0x41
    04 be8d8b94 832a252b nt!MiCheckVirtualAddress+0x3b
    05 be8d8c00 83253aa8 nt!MmAccessFault+0x1db2
    06 be8d8c00 832ae2dd nt!KiTrap0E+0xdc
    07 be8d8c8c 832adf84 nt!MiFindNodeOrParent+0x17
    08 be8d8ca0 834708a0 nt!MiLocateAddress+0x41
    09 be8d8cc0 83470bc7 nt!MiSecureVirtualMemory+0x79
    0a be8d8cd8 98554912 nt!MmSecureVirtualMemory+0x1a
    0b be8d8d20 832508c6 win32k!NtGdiSetBitmapBits+0x46
    0c be8d8d20 776670f4 nt!KiSystemServicePostCall
    WARNING: Frame IP not in any known module. Following frames may be wrong.
    0d 0015d580 00000000 0x776670f4

    Start Menu\Programs\Registry Easy
    Windows 7 doesn't require any programs which make changes to the operating system and registry, these programs tend to cause problems by modifying and deleting files.

    Windows is a closed source system. Developers of registry cleaners do not have the core code of Windows 7 and are not working on definitive information, but rather they are going on past knowledge and experience. Automatic cleaners will usually have to do some guesswork.

    Modifying registry keys incorrectly can cause Windows instability, or make Windows unbootable. No registry cleaner is completely safe and the potential is ever present to cause more problems than they claim to fix.

    Registry cleaners cannot distinguish between good and bad. If you run a registry cleaner, it will delete all those keys which are obsolete and sitting idle; but in reality, those keys may well be needed by some programs or windows at a later time.

    Windows 7 is much more efficient at managing the registry than previous Windows versions. If you run any other registry cleaner and do not know precisely what you are doing, you will have problems down the road. There are no gains to be had from using a registry cleaner and the risk is great.
    Run Driver Verifier to scan for any corrupted drivers which may be causing problems, this program works by running various stress tests on drivers, in order to produce a BSOD which will locate the driver; run for least 24 hours:

      My Computer

  3. Posts : 26
    Windows 7 Home 32 bit
    Thread Starter

    Then here comes another problem , my PC now freezes less than a minute(5 - 30 sec) after the welcome sign. Even in Safe Mode. Then after that the PC will not boot
      My Computer

  4.    #4

    Boot into Safe Mode with Command Prompt, and then type the following command:

    verifier /reset
    Reboot the computer, and then attempt to boot into Windows normally. Driver Verifier should be disabled.

    Update your System Specifications with Speccy, and then copy this information into your System Specifications: Go to your UserCP, and then select Edit System Spec in the left pane. Copy the information from Speccy into the required fields. These System Specifications will then follow your every post.
      My Computer

  5. Posts : 26
    Windows 7 Home 32 bit
    Thread Starter

    I'm sorry for my 2nd reply(It's incomplete). The PC freeeze at the startup before I even download and use Driver Verifier
      My Computer

  6.    #6

    You don't need to download Driver Verifier, it's a in-built tool for the Windows operating system. So you can't even boot into Windows normally or within Safe Mode in general?

    Troubleshooting Windows 7 Failure to Boot
      My Computer

  7. Posts : 26
    Windows 7 Home 32 bit
    Thread Starter

    I can boot in both modes but it will freeze after Windows loads (approximately 5- 30 sec after it loads) then the PC will flash a "No Signal" warning then black screen.
      My Computer

  8. Posts : 26
    Windows 7 Home 32 bit
    Thread Starter

    Miraculously, I managed to run Driver Verifier and got 2 Different BSOD's at 4 different restarts and boots. 1A and 10000008e.fI already disabled driver verifier to stop the BSOD's. Here are the minidumps.
      My Computer

  9.    #9

    BugCheck 1000008E, {c0000005, 9817d640, b7b398bc, 0}
    Unable to load image \SystemRoot\System32\Drivers\aswSnx.SYS, Win32 error 0n2
    *** WARNING: Unable to verify timestamp for aswSnx.SYS
    *** ERROR: Module load completed but symbols could not be loaded for aswSnx.SYS
    Probably caused by : aswSnx.SYS ( aswSnx+1c754 )
    0: kd> !error c0000005
    Error code: (NTSTATUS) 0xc0000005 (3221225477) - The instruction at 0x%08lx referenced memory at 0x%08lx. The memory could not be %s.
    0: kd> lmvm aswSnx
    start    end        module name
    8d404000 8d4bc000   aswSnx   T (no symbols)           
        Loaded symbol image file: aswSnx.SYS
        Image path: \SystemRoot\System32\Drivers\aswSnx.SYS
        Image name: aswSnx.SYS
        Timestamp:        Tue Oct 30 22:43:54 2012 (5090582A)
        CheckSum:         000C0E32
        ImageSize:        000B8000
        Translations:     0000.04b0 0000.04e4 0409.04b0 0409.04e4
    Your avast! Virtualisation driver seems to be causing problems, please remove avast! completely with the avast! Removal Tool, and then install and run full scans with these free and proven alternatives.

    Install and perform full scans with:

    Remember to install the free version of Malwarebytes not the free trail; untick the free trial box during installation. MSE is the most lightweight and compatible with the Windows 7 operating system

    You can also view this thread for a complete free and lightweight security protection combination:

    b7b398bc -- (.trap 0xffffffffb7b398bc)
    ErrCode = 00000002
    eax=00000001 ebx=00000001 ecx=00000000 edx=ff9d1d28 esi=ff9d1d28 edi=ff547df0
    eip=9817d640 esp=b7b39930 ebp=b7b39c80 iopl=0         nv up ei pl zr na pe cy
    cs=0008  ss=0010  ds=0023  es=0023  fs=0030  gs=0000             efl=00010247
    9817d640 c70018000000    mov     dword ptr [eax],18h  ds:0023:00000001=????????
    The exception which couldn't be handled was caused by a NMI (Non-Maskable Interrupt), which usually indicates some form of hardware failure, however, looking at the stack we can see that avast! seems to be causing problems. Furthermore, generally all the dump files tend to indicate something related to graphics, which may explain the loss of connection between the monitor and graphics card.
      My Computer

  10. Posts : 26
    Windows 7 Home 32 bit
    Thread Starter

    Freeze after avast uninstall

    So here's what happened.
    After I booted into Safe Mode and uninstalled avast!(I used the Avast Uninstall Utility). I restarted to Normal Mode and tried to play LoL to check if everything's normal again. My PC did not froze until champion select. I was waiting for a BSOD but it never happened and it stayed frozen. I turn off'd the computer by holding the power button and I cannot reboot my PC. Now I'm waiting for my PC to boot again and to check if there are dump files
      My Computer

Page 1 of 2 12 LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 19:54.
Find Us