BSOD whyle playing

Hi swosh.

Code:

*******************************************************************************
*                                                                             *
*                        Bugcheck Analysis                                    *
*                                                                             *
*******************************************************************************

Use !analyze -v to get detailed debugging information.

BugCheck 100000EA, {fffffa80055ccb50, 0, 0, 0}

Unable to load image \SystemRoot\system32\DRIVERS\atikmdag.sys, Win32 error 0n2
*** WARNING: Unable to verify timestamp for atikmdag.sys
*** ERROR: Module load completed but symbols could not be loaded for atikmdag.sys
Probably caused by : dxgkrnl.sys ( dxgkrnl!TdrTimedOperationBugcheckOnTimeout+37 )

Followup: MachineOwner
---------

It is either the display driver or the display hardware that is causing the BSOD, apparently.

If the issue started to occur, roll the driver back to an earlier version.
Device Manager - Roll Back Driver
If the rollback button is grayed out, uninstall the display driver manually, and install an earlier version.

If you know that the issue is there irrespective of the display driver (we have two BSOD dumps only, so we cannot judge it); or if the situation is the same with the other driver version too, stress test the Graphics Card using Furmark.
Video Card - Stress Test with Furmark

Check if the Power Supply Unit (PSU) supplying adequate power to the computer or not.
eXtreme Power Supply Calculator
Also let us know the wattage of the PSU.

Is the computer hot? Report us the heat of the computer after a couple of hours of your normal usage. Upload a screenshot of the summery tab of Speccy. Alternatively, you can publish a Speccy snapshot too: Speccy - Publish Snapshot of your System Specs .

Let us know the results.